New permanent magnet motor on youtube from Roobert33

[marianpiti]

The prototype is ready, but because of an error (the guy who did the parts in his mini-factory made an error), it does producing torque, but is not rotating...like you pushing the wall... you do a lot of work, but there is no work done because the wall didn't move ... Anyway...last week I did measure the torque from system and is very good...This week I talked with the guy with CNC (not Clanzer ) and he will modify the part with error... with no extra costs... So, I hope next week is ready and does rotate.

Marian

[Omnibus]

@CLaNZeR,

You're one of the few researchers in these forums who do actual work at that with great skill and determination. I'd like to say to you once again that I admire you for that. You're setting an example for everyone of us how one can achieve goals against all odds finding fun in addition.

Now, regarding the case at hand. I'm having a great deal of trouble getting the basic setup properly made. Even the making of a right axis turned out not to be a straightforward project let alone a close to adequate cam. As I said earlier, one needs watchmaking precision and that so far has never been the case, the least in what I have done so far. Because of lack of equipment and the specifics of the fine mechanics needed most of the time the models are a crude resemblance of what is needed. This time I'm determined to make it closer to what's right. I'm ready with the drum and the arrangement of the magnets and the next step is to make the cam properly. That darn cam is the stumbling block in all those types of devices. Take Torbay's motor or the ramp of Sjack Abeling machine, for instance. Here there's a precision metal abrasion machine (in another town, unfortunately) and I'll see what I can do this week. If not, will continue that in the states. I'm leaving by the end of this week. Will definitely report back here if there's any development in that important aspect (the making of the cam). I think everyone of us should cooperate and share experience as much as possible so that we can facilitate our activity in making a working OU machine.

[Omnibus]

@marianpiti,

What do you mean when you say you measured the torque? Do you have an actual working machine, although crude, and now you're just asking that guy to make it more precise?

[shylo]

one excuse after the next usually means bullshit.....but not always..shylo

[shylo]

if I had a working device I would plaster it all over the internet that way there would be no way of being silenced.............if I ever get my wheel to work the last place I would go would be to the patent office.............the oil barons will kill you.......it's time to get rid of the powers that be.......shylo