Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



a strange finding

Started by Cairun, July 09, 2011, 11:54:16 AM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Cairun

Quote from: MrMag on July 09, 2011, 02:30:11 PM
My guess is that since the magnets are opposing, the flux lines are fighting each other. When the bar of steel approached the magnets, the flux will tend to be attracted the bar instead of fighting the other magnet. I hope this makes sense.

Thank you for offering answers to my question. 
I had similar thoughts about this. 

Thanks,
Alex

futuristic

You have to rename file before you can run it in the FEMM.
Try this: select the file with mouse -> press F2 key, replace text "txt" with "fem", press Enter.

I think now I understand where is the steel bar, will do another sim.

futuristic

Is this how you have it?

Magnets close together:
http://file.si/pfiles/183688/bar-on-top1.png

Magnets apart:
http://file.si/pfiles/183687/apart.png

If this is not the correct setup then please draw it...

Cairun

Quote from: futuristic on July 10, 2011, 01:26:23 AM
You have to rename file before you can run it in the FEMM.
Try this: select the file with mouse -> press F2 key, replace text "txt" with "fem", press Enter.

I think now I understand where is the steel bar, will do another sim.

I can rename the file, but I cannot seem to change the file extension.

Thanks,
Alex

Cairun

Quote from: futuristic on July 10, 2011, 01:40:55 AM
Is this how you have it?

Magnets close together:
http://file.si/pfiles/183688/bar-on-top1.png

Magnets apart:
http://file.si/pfiles/183687/apart.png

If this is not the correct setup then please draw it...

This is close enough to the set up I had. 
However, if I am reading the results right the simulation is showing the opposite of what I found.

Thanks,
Alex