Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Help translate! Polish video of possible Overunity parallel path motor on bike

Started by gotoluc, May 25, 2011, 10:59:53 AM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

gotoluc

Hi everyone,

if someone who is Polish could tell us what this man is doing with his parallel path motor as it looks very interesting.

Link to videos: http://www.youtube.com/user/scienculo#p/u/4/gYzfF7aPacY

Thanks for your help and sharing

Luc


pix

Hi,
This is aquick translation.Seems this fellow is really up to parallel path motor application.He has more vids on this subject.

>>>>This is a quick example from labolatory table, this set up wasn't tested on the street yet.
This is only to show that paralel path electrical motor could be used to power a bicycle.
At this moment supply is taken from three batteries and voltage is 37,1V and current is 1,13A.
At the same time when motor runs , part of the energy is re-captured to charge 3 batteries, presently we have voltage about 43 V on them.
To those batteries is connected also a light bulb, that draws a current about, hmmm,100mA, and here we see on the scope curve on the transistor drain (upper), and on the diode which is connected to energy recovery circit (lower).
Optical sensor checks rotor position,giving a signal to electronic circuit, signal is amplified by MOSFET and sending back to the electric motor.
I didn't check yet revolutions (motor speed), but speed could be regulated (potentiometer), for the moment I don't put maximum rpms.I am afraid that this diode has too low voltage.I speed up little bit,now w have on supply side 37 V and 1,5 A. I am afraid this voltmeter don't show correctly on the charged batteries.I slow down and accelerate a bit now. This is only half of the max. speed. I guess at this moment I should travel about 40-50 km/h. Almost 37 V and current 1,8 A.
Of course such labolatory test is not the same like during real drivig, but shows that paralell path electric motor could be used to drive a bicycle.<<<<
Regards,
Pix

pix

I just want to point,that this test was run with free rotating bicycle wheel, without any braking.Of course in real conditions power needed to move a bicycle on the road will be much bigger, so voltage and current readings on supply side would be different.
This should be tested on the road.
Regards,
Pix

gotoluc

Thanks Pix for taking the time to translate one of his videos.

I looked at some of his other videos. I'm not sure if his motor pulls more current when under load.

Could you look into this please and report your findings.

Thank for your time and sharing

Luc

scianto

gotoluc
It is my youtube channel and my tests with PPMM was discussed on this forum:
http://www.overunity.com/index.php?topic=9713.0

All the videos have English subtitles. If you don't see them, just switch them on.