Kapanadze Cousin - DALLY FREE ENERGY

[Tomtech29]

I do not know if that makes any sense but if so it could be work

[itsu]

something I will see that there are those arrows on the side of the sine They are small you are able to move it to the left or right ?
track to the top sine wave peak

The picture (screenshot) in this post of yours does not belong to the link i presented.
This purple sine wave is not the Wima cap resonance voltage, its the loaded current transformer output (yellow is the unloaded current tranformer output).
Instead i referenced to this screenshot shown here:

http://overunity.com/12736/kapanadze-cousin-dally-free-energy/msg463623/#msg463623

Itsu

[Jeg]

This is it Itsu.

PWM percentage even at 45% (maximum) does not increase the voltage across inductor's capacitor over than 310V.!!!

[itsu]

Thanks Jeg,

your gate signals look good, but there is something wrong with the drain signals.
You now drive the yoke almost entirely on those narrow 248V peaks, fired simultaniously from both MOSFET's i think.

It almost looks like your primaries are in bucking mode and the signals counter act on each other.
Is your 24V supply strong enough to deliver the needed current?


Itsu

[Jeg]

It almost looks like your primaries are in bucking mode and the signals counter act on each other.

They are in bucking mode cw-ccw since yesterday. Do you think that this is the problem?. I use a 220 to 24v dc converter at 16.5A

It is not logical both mosfets to fire together.