Kapanadze Cousin - DALLY FREE ENERGY

[John.K1]

Hi Dog- This video it is like a complete information how to do it- in theory- no schematics.

Very important- synchro electronics has to keep resonance what ever happens. (it change with bulbs)

2-5 KV is perfect voltage on anntena- no need more. On antenna has to be uni polar pulses , the ferite rod cleans them from the rubbish. Kacher strongly not recommended.

[Tomtech29]

Hi Itsu, guys.

Not sure how could I miss this movie -even when  it is in my folder for ages.  I consider that  movie very valuable.  I guess most of you has seen it, no harm to discuss what he says there. I am at work right now, have no time to make comments.
Ruslan  made lots of "valuable" points in there. I'll be back later on Just start with the schematic- Ruslan says it is absolutely right.

https://dl.dropboxusercontent.com/u/61581587/%D0%9A%D0%B0%D0%BA%20%D1%8D%D1%82%D0%BE%20%D1%80%D0%B0%D0%B1%D0%BE%D1%82%D0%B0%D0%B5%D1%82%20%21.mp4

Hi.
This is an interesting trick you find that. I still insisted on the synchronization current push pull
for the present moment, no one showed how to operate the PLL if not Itsu.-I regret that failed lack of positive effect.
I still think that to a large extent, it depends on maintaining resonance in the tank! and the next step is to put spikes on top of the current,so bifilar coil with ferrite rod is to suppress ringing off impulse
on a Tesla coil served with a semiconductor one half sine!
as I understand it the problem is that I do not know how to control the current in the tank to not waned?
Somebody tell me to stop because I'm repeating myself, and there is no reason to think so...
But this system is so twisted that in other versions like no PLL This is damn frustrating?
what is your opinion on this topic?

[Dog-One]

Very important- synchro electronics has to keep resonance what ever happens. (it change with bulbs)

If I can figure out how to get the same current sense waveform he is getting, then doing a PLL lock on the resonant frequency is easy.

Next, all we need is a trigger source--using the positive peak of the current sense is perfect.  Then we delay if needed and create a pulse of specific width to properly drive the tesla primary.  After that we take the tesla secondary signal and tune the bucking coil ferrite rod to only pass a unipolar pulse to the antenna.

Sounds easy enough to me.  Lets get to it and see what happens...

[Tomtech29]

"If I can figure out how to get the same current sense waveform he is getting, then doing a PLL lock on the resonant frequency is easy."
I have no idea how it works PLL but as I tried to manually tune the resonance peak a further additional bulb I not crossed the threshold of 300 Watt why?
how I am I to understand that performs automatic frequency control if he also controls the phase shift of separately from each port It will have an impact on the flowing current to the coil?
I would have asked for demonstrations as possible!
Thanks

[x_name41]

this archive contains schematics, video and detailed description for successful replication of the Ruslan Kulabuhov generator

for more info see http://realstrannik.com/forum/freeenergylt-antanas/708-povtorenie-ustanovki-free-energi-kolobukhova#38500

ooops, sorry but I saw that the material already has been released