Kapanadze Cousin - DALLY FREE ENERGY

[Dog-One]

After I eye ball several time at these videos I draw my own schematic. See attachment.
Look very smart design in simplification and efficiency assuming is not a hoax.

I commend your effort trying to decipher the circuit schematic of this device.

What I see has me cautious of its accuracy.  The main item that stands out is the circuit path of the load.  You will notice it traverses the secondary of the coil on the left which probably has relatively small conductor wire.  Hard to imagine 2000 watts passing through this wire without it immediately bursting into flames.

[Void]

Nick, Geo. Regarding the video with the guy lighting the light bulb on the shovel,
I have done some more testing and the best I could get a kacher circuit to light up
at fairly low input power was to partially light a tiny 12V, 0.75 Watt bulb. That guy in
the video must be driving the tesla coil with some sort of special pulsing or something
along those lines. At any rate, based on my tests,  a kacher driver will just not do what is shown
in that video.

[Void]

After I eye ball several time at these videos I draw my own schematic. See attachment.
Look very smart design in simplification and efficiency assuming is not a hoax.

Hi skywalker66. Here is a link to an earlier device with a bit different configuration, which
seems to be by the same guy. According to the comments for this video, the guy's name
is supposedly Андрей Брюховецкий (Andrew Bryukhovetsky), and I think they are saying
he is from the Ukraine. As in the other videos, the guy covers up portions of the circuit to
hide what he doing.
http://www.youtube.com/watch?v=8GMmIslMhrg

P.S. If this guy's devices are not fakes, then it would seem that he has figured out the Kapanadze effect.

[AlienGrey]

Yes I found that one-two off one of the other threads, Just look at the battery cables 200 amp do you think ?

One coil is the TX and the other could be RX and a spark gap ?

I don't think I will be4 investing in it thanks

[lost_bro]

I need to understand that so my upcoming PLL circuit will not lock onto the wrong frequency.

Good day Verpies

I am looking forward to seeing your PLL implementation.......

take care, peace
lost_bro