Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Kapanadze Cousin - DALLY FREE ENERGY

Started by 27Bubba, September 18, 2012, 02:17:22 PM

Previous topic - Next topic

0 Members and 184 Guests are viewing this topic.

Hoppy


AlienGrey

Quote from: Hoppy on December 28, 2016, 01:45:36 PM
OK. Thanks Geo.
Geo Hi one question I have to ask, while I was doing some experiments I noticed a lot of heat from my original grenade coil wound with PVC insulated cable on PVC drain pipe ;) (cheep job) I was wondering how or what did you use to wind your device on ?

It might be an idea to use a postal tube but i don't think they supply in small quantities.  Other wise the unit will die of short time sag and i wouldn't wish that on any one  :D

Tomtech29

Quote from: Jeg on December 28, 2016, 11:00:15 AM
Hi Tomtech

Can you describe with a few words how does he modulate his output? I speak about the attached video. Thanks
Hi
As we see the arrangement of the circuit kacher we have two kinds of operating mode:
- One of them is known as the multiplier voltage number of consecutive windings and the number of windings is reduced frequency and vice versa.
Thick wire coil primary winding CCw a secondary winding Cw , while the lower portion It has a positive pole (which it is a permanent positive power source) while a negative portion thereof is broken.
in short, we get oscillations where we see the form of a sinusoidal signal near the coil.
- the second mode : obtaining electromagnetic field (would compare to the concert stage where the microphone is placed near the speaker called a loop feedback) :D
in the case inverts the polarity of the primary winding,but that's not all it is also necessary kind of loop conduit extending inside the tube "I guess that is part of the drain current" Let's go back to the primary coil
the number of windings is not accidental by reduction of the gap between the windings tune the length wave , On the oscilloscope we see the nature of the modulation commonly called fish
We will also need use a radio receiver will serve as a monitoring or detection,should be able to hear the squeal at a given frequency.
I realize that my description is unprofessional excuse me I tried but I is not getting for the better :D
Does anyone of you has already carried out this type of experience and what do you think?

Hoppy

Quote from: GeoFusion on December 28, 2016, 11:43:02 AM
Hi Hoppy,

Mains earth wire is completely disconnected from PSU 24V in the recording. Only Phase and Neutral are used to power it.
Ground ( Earth ) is another pin of 0.5M in.
Even asked a cousin to bring a  Back up UPS for the test last night, not connected to mains, just from backup battery operation.
Ground connection of UPS was as well disconnected. It as well and getting the awesome results.

Geo,

If you are able to use the UPS again, try raising or lowering it to various heights above ground with wood blocks or cardboard boxes to fine tune / vary lamp brightness.

AlienGrey

Quote from: Hoppy on December 29, 2016, 05:25:20 AM
Geo,

If you are able to use the UPS again, try raising or lowering it to various heights above ground with wood blocks or cardboard boxes to fine tune / vary lamp brightness.
Hoppy are you going to put yours in a tree house or use it on a hover craft ? :D I know ask him for a guarantee !  ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D ;D