Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

https://www.youtube.com/watch?v=Adwf0NnQSyk

The point had already been made some time back in this thread that the measuring method is incorrect.

[AlienGrey]

it's like Morecombe and Wise on here, two separate threads, and one looking for how the device works (particle physics) and an other of a what if thing! Hello but I have not seen a single explanation into how any of it works or one that does work, So any chance we can center on reality in here ? 

Look guys when they talk about resonance THEY ACTUALLY MEAN RESONANCE, THE Egyptians had this philosophy AS ABOVE SO BELOW they were NOT kidding !!

A|G

[stivep]

quick response :

AlienGrey -Wesley I'm just trying to picture what's happening in my head regarding the old boiler ignition system, so are we to assume we wind a caduceus coil x2 and we feed it with the energy from the EHT and in doing so energy is pulsed in a sine wave trough the caduceus coil, the only problem here is wont it over heat and burn out, could you suggest how this should be done (a spark gape perhaps) just suggesting that but i don't think that alone would be sufficient   

I think about making video  that would  explain it better. There is a lot you guys added into  it.
I do thank you very much about your comments
You are great team of dedicated individuals
Wesley

[SolarLab]

F.Y.I.

Continuing development --- a portion of one possible "Functional Theory."

For Reference only: A Block Diagram Scema of a typical FE/CE generator;
[[СхемаРусланавертикально-2.JPG - driving Ruslan Vertically]]
(Unable to locate the original source at this time to provide due credits).

  SEE ATTACHMENT

Сергей STALKER video - "Пуш-пулл схема и настройка [Push-pull scheme and setup]"
https://www.youtube.com/watch?v=XDXTxPRPxSU
Pay attention to the COMMENTS. Some of them do contain valuable information. 

{Note that with a little experience you will quickly be able to distinguish between
valid questioners - answers - commenters and the disruptive lamers and trolls --- it is much the
same as what you have had to learn to do to effectively use the many forums and other sources}.

STALKER has a series of excellent technical videos on his youtube page - they are all well
worth the review time.

Scientific Criticism (video) - "Standing waves in the Tesla transformer, resonance, transformation ratio" 
https://www.youtube.com/watch?v=oyODF8FWs_8
Select EN or RU CC/Subtitles as needed.
Again, observe the COMMENTS section.

Pavel Korotaev - "Совпадение собственной частоты ТТ с собственной частотой катушки
съема [The coincidence of the natural frequency of the TT with the natural frequency of pickup coils]
https://www.youtube.com/watch?v=xMeUeI7Gy_0

Food for thought - TBD:

On top of the main Grenade coil there are two (2) extra dual coil layers that cover one half (1/2) and
one quarter (1/4) of the main coil. Their function is not clear, to me at least, but one explanation might
involve manipulation of the Second and Third Harmonics; therefore, with respect to Helical Cavity Filters;
Peter Vizmuller's US Patent US4422058 "Folded-Over Helical Resonator" may provide some insight.
This should be easily verified as time permits.
http://www.google.com.uy/patents/US4422058

Bit by bit we attempt to unravel the technical mysteries of an FE/CE generator in an effort to determine
what parts are explainable using conventional engineering and physics knowledge and what parts, if any,
remain unorthodox; yet to be discovered and hypothesized.

FIN

[SolarLab]

F.Y.I.

Automatic Controller - one possible design approach.

The exchange below is from the comments section of a Ruslan video which hopefully provides some
insight into why the following LINK is given.
... Food for thought? ...

https://www.matrixtsl.com/flowcode/

In brief - FLOWCODE facilitates high performance microprocessor development, design, simulation and test without any
programming language knowledge. Once a functional system flow-chart is created you can test your design/sequence, etc. then
Flowcode will do the high level (C) software coding, machine code interpolation and microprocessor chip programming.
You can develop an "automatic controller" in a matter of hours using some very powerful ARM, AVR, PIC or Arduino processors.

Shameless plug: Have used Flowcode for years, easy to learn and use, works great and has a very good support network.

Scenario that prompted this "gray line off topic" post:

Ruslan Kulabuhov video comments - "Полезно знать некоторым ! [[  Good to know some!  ]]"
Published on Nov 4, 2015.  Comments for this video are disabled on youtube. As most are aware, youtube video comments
do have their drawbacks!

A typical marketing troll contact request followed by an "experienced developer [Stalker]" response (every inventor/developer receives
literally thousands of these "great offers").

HOWEVER, maybe even more importantly, some "useful," thought provoking, discussion can be of great value. For example in this
exchange STALKER brings out the real need for an "automatic controller for data systems - like the on-board computer for a car."
-----
neochel2012
Good day Ruslan!
I just recently visited the genius in its simplicity idea regarding promotion of the Council of Europe and the monetization flyweight
available in abundance practical developments.
I am referring to the launch of pay-master class is imprisoned for a specific device.
This event is to collect good cash no doubt requires investments for which I am ready to go, unless of course you may be interested.
A definite plus - moving away from direct production and research component - the same device can be sold thousands of times in
fact - a physical product is converted to digital.
Contact me if interested     ........@inbox.ru

Сергей STALKER
All those who want to sell this kind of design is very much mistaken, they can be so easy to distribute. And the reason is not a global conspiracy,
or oil companies, and in the process of setting up such devices.

By design, they are simple enough, but it's worth a little to change the conditions in which they were assembled and tuned and come!
The technology is not yet very stable.

Therefore geniuses commerce must first hate Hilo to invest in the process of creating an automatic controller for data systems
(like the on-board computer for a car), as well as the experts in this field have the practical knowledge is extremely small, and the
knowledge of classical physics, to say the least in conflict with practice in the art, and hence the problems arising.

It's like with the purchase of equipment for the satellite tv to buy a little, wait to visit specialists for setting up, and there is not taught in
state uchrezhdeniyah. I pay online master classes that does not give !, it needs at least to develop theoretical and then practical study,
to educate people, and after a terrible start hemorrhagic, with all the suffering that could barely understand anything in classical electrical
engineering. And if you dial up staff for paid hot phone and consultations, so be it with iron nerves they brain tear in the first days of the
questions like "where to buy? How to connect? And why I paid and I did not get?

You there all f..king mashenniki and .t.d. " But earlier this hack your internet proektik with pay master class and in parallel will sell, and
not spending all your preparatory work and thank you not say, and then there is someone who is just out of kindness all will merge freely
available and will copy all who need.

Do you want such a thing, sit solder bratuha. And if you really want it and distribute it to have the means and time-forget about profit and start to work!
-----
NOTE: the attached images are nothing more than sizing/quality/view-ability - posting tests for possible future use (unable to preview attachments).

FIN