Kapanadze Cousin - DALLY FREE ENERGY

[AlienGrey]

http://www.ebay.co.uk/itm/FREE-ENERGY-GENERATOR-ZERO-POINT-ENERGY-7-3Kw-220V-/132106746213

Ah! the famous John Searl Rotary Encoded magnetic Drive and generator Searl Effect Generator SEG. I wouldn't mind betting its a fraud!

I couldnt see John knowingly Sell an original since no others Have been sold or have there ?

[arhitrade]

Working free energy generator (rus)
https://youtu.be/o2Z0Vydg278

His calculation - http://gorchilin.com/articles/coil/combi_3?lang=en

[T-1000]

"But why did the lights come on again and why didn't it short and why were there no sparks...

perhaps because the gas in the bulbs was being ionized and not the filaments?

perhaps because it was not normal electricity?

perhaps it was radiant RF being fed into the bulbs by the Tesla coil in parallel with the low primary and high secondary coil pairs?"


YES...see clip... of " RF type high frequency electricity".https://www.youtube.com/watch?v=OGkZIx4rseE
Acca

See the difference between those two?

[NickZ]

Nick,

Tip: Test each circuit element as you proceed. Don't just connect everything together and wonder why it doesn't work or a component smokes! Firstly test that the voltage regulator(s) is functioning correctly before connecting power to the TL494. With the TL494 in circuit, test the frequency and duty controls by scoping the outputs for the correct waveforms. Then connect and test the FET drivers and scope for correct waveforms before connecting the FET's and snubbers to supply rail and load.


  Where to connect the scope probe to check the tl494 wave forms? Without the get drivers installed.
  Filters seem to be working OK.

[Hoppy]

Nick,

Pins 9 & 10 to ground.

Please resize your image!