Kapanadze Cousin - DALLY FREE ENERGY

[nelsonrochaa]

But you refused to show us even the scheme of your simple Amazing oscillator. If You don't want to make money with selling them and if you really want to explain others its principle - what prohibits you to show us at least the scheme?

Zephir ,
I did not explain about the work of that circuit "amazing oscillator" because i respect the rules that i agree when i sold the idea in at end 2014 to a company by some money . In that time i really need money because i'm Unemployed without any income to survive and that money boost too to i buy first tools   . can you or anyone Criticize me for it?
I think not.
Where was the interest of people in this circuit at that time ?

AHH Akula was fashionable in that time , and my circuit was just a fake copy, that's what I heard at that time by most people. Where are you and the "moralists" when i publish that circuit in 26/05/2014 ?
Did i earn any money by the viewers in my channel ? for sure not just see my views in my channel and you could see that i did not earn money by that .
No one will give me moral lessons .

Nelson Rocha

PS- Zephir if that circuit is simple just put hands to work and think how to reproduce them  .

[ramset]

There is a very active investigation going on around this patent [in link below] from Member Pix....
here post # 29  http://overunity.com/17172/a-simple-question-about-tpu-replication-attempts/15/#.WNcEWLl1pdg

it is an open source investigation and all results will be shared here in TPU section.

brutally simple experiments [for the claimed results] and actually quite similar format [build architecture] to this topic too.??

respectfully
Chet K

[verpies]

It was working for a minute (both outputs),  but now I get just one output that works. So I'm looking for the cause.
Any ideas?

- Burned out TL494.
- Bad pull up resistor on pin10 ...or connections to that resistor.
- Shorted input of the MOSFET driver (inside the chip ...or outside).

[NickZ]

   Verpies:
    There is no signal at the #10 pin, itself,  while #9 pin has a signal output and maybe working OK.
There should be a signal at pin 10, even without the resistors or mosfet driver connected,  but there is none.
I hope that the TL chip is still OK, as it's not going to be fun if I have to replace it, already.
   Did you watch the last video that I posted today?

  Both Stalker as well as Pinoy_tech are following a similar schematic, but not the same. Which may have or may not have the use of the dead time controller. 
  Pinoy_tech design does not follow the same duty cycle wiring path, as the topruslan 7 version that I was following. And he does appear to have the dead time circuit active in his design or version.
So if there are schematic errors or problems related with the dead time controls, I for one would like to know.

[justawatt]

check this out 
http://overunity.com/17197/free-energy-transformer-300w-ac/new/#new