Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

   Color: 
   Ok, I thought that I had already answered you about where to connect the Kacher.
   The input to the Kacher secondary is connected to the 2sc5200 transistor base. The other end of the Kacher secondary is connected to the ferrite bar, and further to the grenade's antenna coil.   Not as shown in your above posted diagram.
   There are many schematics and diagrams around, I use something like the one below. Although I have combined a bit from both Ruslan, Cepren diagrams and ideas, my circuit is somewhat different but at the same time similar to their circuits. I use a full diode bridge instead of the two diodes at the grenade output, like is shown on later schematics.

[color]

https://www.youtube.com/watch?v=vyIEQIHnKmc
We use the lightning principle kacher,
Mr. Romanov uses Townsend discharge.
It is an old future that is over 100 years old.
I understand.

[NickZ]

   Although I could not find Geofusion's channel on youtube, here is one of his videos.    https://youtu.be/qEHKGSLy938
   I would also like to see him posting here again. Most guys building these types of devices have lost interest.
   
   Stalker nor anyone else is showing any new self runners videos nor further information, as of about a year ago.   
   So, don't expect any new self running devices to be shown by Stalker. Especially after Adrian's death.     
   Adrian had also successfully replicated two of Cepren's self runner devices, and showed videos of his device running outdoors. 
   Now he's dead... or MIA at least,  if true.   Adrian seamed to go by different names, also.     https://youtu.be/zbXs0V18fkI

[color]

https://www.youtube.com/watch?v=yQ4_ZwJWFv8

Experiments are better than fuss.

[Hoppy]

   Although I could not find Geofusion's channel on youtube, here is one of his videos.    https://youtu.be/qEHKGSLy938
   I would also like to see him posting here again. Most guys building these types of devices have lost interest.
   

Nick,
Thought I would chip in here just to say that I've not lost interest in building. With me its a case that I know when I'm flogging a dead horse. As I've mentioned before, if there is anything real to all this, then we are missing the fuel. No amount of frigging about with oscillators, frequencies and coils of wire are going top produce a self-runner, without an understanding of what the fuel is and its not the ground or ambient in my opinion. Take Kapanadze's box devices. We have all heard the start-up noise which is almost certainly coming from the vibrating laminations some type of transformer running at 50Hz / 60Hz. Now either his device is plugged into the grid in some way or he is running from an in the box inverter and battery that are creating a transmutation of some kind of fuel into electricity to power his several KW bulb load.