Kapanadze Cousin - DALLY FREE ENERGY

[00]

for the cell and guruji!


00

[guruji]

Do you mean there has to be a connection to the alumium tube to the driver circuit??


I'm still constructing the orthagonal coil


Thanks

[Hoppy]

The 12V Lamp is not lit.
However there is a small resonance that has maximum
when the thick coil is moved to the right.
With the osci - probe on the cap there are 1V pp .
The gap btw the 2ferrite coils is 1 inch = 2,5cm.
I don't have a thicker copper tube for the primary
, if this crucial for further improvements.
Please 00 give some advice.

The original schematic posted by 00 (post 2355) shows a mains 220V lamp as load!

[00]

Do you mean there has to be a connection to the alumium tube to the driver circuit??


I'm still constructing the orthagonal coil


Thanks

connect  pin zero( ground pin on flyback) to alluminium tube. there was mistake in previous upload figure now corrected.

00

[TheCell]

@Hoppy
meanwhile I tried a 220V bulb  with no result. Only small resonance is there, which imho is necessary . My DC-HV is not stored in a cap (I spent all my caps for the resonant tank/will have to buy them) . Next thing the thick primary ; maybe an important step is to anneal the copper   (mentioned by tiger/annealed copper = semiconductor) . You always see them with a dark oxide layer .