Kapanadze Cousin - DALLY FREE ENERGY

[itsu]

Itsu,

Ref the Ruslan video link you posted earlier: -
https://www.youtube.com/watch?v=Y8snEOzF9R4#t=163

I have just noticed the clip below, showing a white mains flex with a full three core connection to the SMPS. This looks strange as this cable should be connected into the output of the device as loop-back, given that he shows us a self-runner here started with the 12V battery. The white cable appears to disappear down towards the floor and its not going to the lamps, so any guesses where it terminates.

Regards
Hoppy

yeah very strange, it was also mentioned for this video why the PSU light was on while everything suppose to be off, see comment in red circle below.

Regards Itsu

[Hoppy]

yeah very strange, it was also mentioned for this video why the PSU light was on while everything suppose to be off, see comment in red circle below.

Regards Itsu

Yes, it all adds up Itsu!     The Kapanadze latching relay trick!!

What direction do we go in now??

Regards
Hoppy

[itsu]

Yes, it all adds up Itsu!     The Kapanadze latching relay trick!!

What direction do we go in now??

Regards
Hoppy

Well, i hope that our Russian friends (where are they?) can shed some light on this, perhaps its being explained lateron by Ruslan that it was,
like you said, a testrun with the PSU attached to mains.
My Russian is somewhat rusty lately.

Regards Itsu

[Jeg]

Guys thanks for your scope shots.
Hoppy
I made the same trick by taking supply for katcher from the choke behind mosfets. I also took out my 1000uF cap and I replaced it with 1uF. Supply connected to katcher through choke of around 100uH

When I fired it, my dimming lights gave a lot of light! Almost as much as Urfa's. The same time, voltage from katcher got higher as much as 4 times than before. After my initial surprise, I noticed at my two amber meters one for mosfets one for katcher, that when I was pressing katcher's button my consumption was going much higher. Total system drainage went from 2A to 8A, while katcher alone consumes 2A. The rest went to mosfets. By activating katcher, it pulls current, and because of the fact that is connected just between yoke primaries and their choke, makes them to also pull more current. And that is the reason for all this extra light. I hope I am wrong. Please check it.

[Hoppy]

Guys thanks for your scope shots.
Hoppy
I made the same trick by taking supply for katcher from the choke behind mosfets. I also took out my 1000uF cap and I replaced it with 1uF. Supply connected to katcher through choke of around 100uH

When I fired it, my dimming lights gave a lot of light! Almost as much as Urfa's. The same time, voltage from katcher got higher as much as 4 times than before. After my initial surprise, I noticed at my two amber meters one for mosfets one for katcher, that when I was pressing katcher's button my consumption was going much higher. Total system drainage went from 2A to 8A, while katcher alone consumes 2A. The rest went to mosfets. By activating katcher, it pulls current, and because of the fact that is connected just between yoke primaries and their choke, makes them to also pull more current. And that is the reason for all this extra light. I hope I am wrong. Please check it.

Hi Jeg,

Yes, my observation also. As Mag reported, the angry spark increases current draw. Waiting for divine guidance!