Kapanadze Cousin - DALLY FREE ENERGY

[Void]

How much mA you need to lid the LED? 

Hi John.K1. Many of the LEDs that are available these days are very efficient
and start to light up in the low uA range of current. Many can light quite brightly with only
a few mA of currrent through them. Lighting LEDs therefore doesn't take very much power
at all. That's why LED lights are so much more efficient than many other types of lights.
All the best...

[Hoppy]

Further to my post 7352 on page 491, I have posted three images below showing where I now think Ruslan placed his battery. The first clip is a repeat of the previous one posted showing a close-up shot of Ruslans cheapo Chinese SMPS. The second image is my SMPS modified as a no-break computer supply. I have removed the terminal block to PCB supply wires to give a clear view of how the PCB is cut to separate the strip terminal block.The third image is a side-on view of the battery compartment which will take up to a 10A/hr Lithium ion plat pack. Ruslan probably uses less than 10A/hr, as we see his cap voltage dropping noticeably during the demonstration on his latest video.

[John.K1]

Further to my post 7352 on page 491, I have posted three images below showing where I now think Ruslan placed his battery. The first clip is a repeat of the previous one posted showing a close-up shot of Ruslans cheapo Chinese SMPS. The second image is my SMPS modified as a no-break computer supply. I have removed the terminal block to PCB supply wires to give a clear view of how the PCB is cut to separate the strip terminal block.The third image is a side-on view of the battery compartment which will take up to a 10A/hr Lithium ion plat pack. Ruslan probably uses less than 10A/hr, as we see his cap voltage dropping noticeably during the demonstration on his latest video.

Just a question Hoppy, do you believe that somebody who equip his workplace with the expensive electronic devices, buys expensive MIKA caps and push the output unnecessary high, as high that diodes burns, no advertisement in his videos, has a reason to fake? Also he is known person and meets known persons.   BTW , have you seen him in new music videoclip?     (The guy in the car)    https://www.youtube.com/watch?v=lPdWkgGgwR0

[Hoppy]

Just a question Hoppy, do you believe that somebody who equip his workplace with the expensive electronic devices, buys expensive MIKA caps and push the output unnecessary high, as high that diodes burns, no advertisement in his videos, has a reason to fake? Also he is known person and meets known persons.   BTW , have you seen him in new music videoclip?     (The guy in the car)    https://www.youtube.com/watch?v=lPdWkgGgwR0

John,

If I did not believe it it was likely, I would not have posted. Yes, I'm trying to reduce mine as well. 

[Jeg]

We need to collect it somewhere and add some current. Don Smith says voltage is for free and the ground makes a current.
To get the answers I (we) must put my hands on the work-desk      

Johnny, yes for both!
I haven't use caps until now but perhaps you can achieve the same. Just tune to the exact sub harmonic that give rise to self frequency vibrations. In deed without testing, things are difficult.
If we tune right Katcher side, its consumption will drop to very low levels.