Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

  Thanks for the tip, Ed.  I'll look into my junk pile for it.

   From what I can see, my yoke/grenade crt is not running at 27+ khz. Only at about 4.5khz, and rings when  it's tuned to it's best output level. So I've got get it out of the audible hearing range, and raise the frequency. The 0.47 tuning cap is not helping the 3 turn coil to the grenades 25, 25 turn coil, to add anything useful. Even when connected by the short jumper to the 168 turns output coil on the grenade. And the three long separate earth grounds, I'm now using don't seam to add much either to the output, either.
  Anyways, I'm still working on it...  and, I'm looking into getting one of  the smaller hand held scopes, to help tune the various frequencies. Most of the cheaper cell phone size scopes only go to 1 mhz or so, and 2mhz or higher is needed.  I've already noticed that my tablet gets affected by the HV from the kacher, when trying out the various oscilloscope apps for android phone and tablets.
 

[Tomtech29]

you can get TL494 out of broken power supply

Hello friends wanted to say hi to all community participants.
Thanks to search for a new plan -current project comes from one gentleman who shared the blessed time,I decided to make a similar experience Unfortunately, somewhere something done incorrectly.
Please correct me/ participant of the forum called:magpwr used the simulation very helpful I would be grateful (if you wanted to see and test).

[Tomtech29]

exemplary arrangement

[Tomtech29]

PCB execution unifersalnej not recommend

[Tomtech29]

The problem is the lack of power at the site of the restriction (20uh)  to the stabilizer LM7805  The problem is the lack of power at the site of the restriction to the stabilizer LM7805 20uh
thanks for the MC34064 (leg No.2 pin) I suppose damaged control or something what do you think?