Kapanadze Cousin - DALLY FREE ENERGY

[Tomtech29]

 
Void" Thank you very much  was looking a long time ago when I ran the analog transmitter "Akula"and now I see what's going on in this project
you need to find the oscillator where the legs fold and will not need to modify the PCB in this range is what to choose?
-but whether I will be able to buy such here may?.
probably will be as you say:"doesn't help much."
but I have to and need look further
NickZ so that I see in this film:
https://www.youtube.com/watch?v=fEu46O9yJKc

[Tomtech29]

 

[Tomtech29]

some can be seen here:

[Tomtech29]

NickZ 
there is nothing to correct you .
unnecessary confusion You're alert

I followed very carefully these wires on the film, and so they must be connected as in the diagram above!
I do not know where they are connected only 2 cables with 28 windings?
what do You think about it 
it is difficult to see there under the cover! (Only two wires white we see as they descend down).

[NickZ]

  As this is getting to be more of a guessing game. I will continue using the older version. But, I always try out different tuning caps, anyway. If a certain capacitor gives me more gain I include it, if it doesn't, I won't.
 

  I made a brand new yoke core today, It's built for my future 24v system, that I am about to switch to. 
It has a 12,12 turns primary, and 28 turns secondary. I will also start with a few more turns on the 3 turns coil, to 5 turns, instead. As I don't get much interaction from my previous 3 turns coil.
  My modified Mazilli crt is already set up for the higher 24v input, as it the has bigger 18v zener diodes, and UF series cross-over diodes, and higher wattage 10k resistors.
  We'll see what happens...
   I never said that I know what I'm doing, so I don't understand the strange comments that I've been receiving here.