Kapanadze Cousin - DALLY FREE ENERGY

[Jeg]

hi jeg,

Thanks for getting the numbers for this kacher portion of the device.
Around 33meters ...37m max of cable is required for kacher portion.

Base on research there is higher capacitance noted for grey pvc pipe as compared to white pvc pipe.

Thanks for this PVC info. I'll search for it!
The above numbers are for the bifi output coil calculation and not for katcher. It is the same core though

[Jeg]

The way Akula explained in his latest video was - he showed bit about finding resonant frequency in coil as antenna then attached ground (his scope is grounded too) and showed how resonant frequency changed. Then he took lower frequency harmonics which was in kHz range and this was a resonant frequency for induction heater circuit (17-35kHz) and using spikes with a frequency of Tesla coil on 1/3rd resonant frequency of output bifilar coil with ground. All ties up with with sine wave on kHz range with spikes on peaks...

Is it possible to attach the link of this specific akula's video please?

[Void]

Is it possible to attach the link of this specific akula's video please?

I think this is the Akula video that was being referred to, in regards to Akula's second self runner:
"Installation №2"
http://www.youtube.com/watch?v=-rALEpvBQig

[magpwr]

I think this is the Akula video that was being referred to, in regards to Akula's second self runner:
"Installation №2"
http://www.youtube.com/watch?v=-rALEpvBQig

Hi,

I am unable to co-relate thick tesla coil winding with this circuit diagram in the video.

Do anyone know where tesla coil with thick wire belong to if compared with winding shown in circuit diagram.
There isn't a clear indication which is the tesla coil in the drawing.
Although it seems obvious this tesla coil layer need to be the first layer,if i am right to mention.
This thick tesla coil was also seen as standing pvc pipe in older video before the winding is completed.

Can anyone please advise  where is this thick  tesla coil in circuit diagram as seen in this video.

We need fit all the missing puzzle together with no doubts before even thinking of replication.

---------------------
In the meantime i am waiting for expensive capacitor and air coil to arrive for don smith.
Valuable time is lost yet again due to long delivery time.

[NickZ]

  The big white coil is not what is being used in the schematic, or on the device.
The tesla coil is the one with the magnet wire, going to the ferrite rod, then to the thick coil antenna. Tesla coil primary is the 5 to 6 turn thick primary with the oscillator connection in the center of it.
I hope that was what you were wondering about.

  Ruslan and Akula are now using very different set ups.  I would personally go with Ruslan's way of doing it, as it's simpler, and still can produce about 2.3kw.
The difficult part of their circuitry is the duty cycle/frequency modulator circuits.
I wish that that those units could just be purchased, instead.