Kapanadze Cousin - DALLY FREE ENERGY

[MenofFather]

"May i ask you MenofFather what direction you are planning to take to built a device."
I not say about my plans, that I build. Then I finish buid, I show, if I not finish, I not show.

[d3x0r]

the kachar ?/3 looks more like a wavelength symbol... [/font][/size]λ  ...[/font][/size] which would be freq*3... low gauge coil is 400... kacher at 1200...

[Jeg]

Because the true "resonant bifilar coil" is the first and the second layer (see TESLA PATENT 512.340).
These first two layers are in fact about half the length of the entire coil Tesla/Kapanadze. 

Hi Corry
Thanks for the explanation which seems that is not very far from reality, even i was expecting an antenna theory behind your statement. For sure the different portions of inductance gives different response in terms of sensitivity to certain frequencies across the entire length of the coil. But needs further investigation.

Mag, nice job man. I hope that synchronicity will be not a problem. Most important seems to be the choise of the right low frequency.  Is there any specific way of choosing it? Until now i believe that dividing by two the high frequency component, you find the right subharmonic at KHz range. For example, if 4MHz is the HF, then 4MHz/2/2/2/2/2/2/2/2= 15.6KHz. What do you think about that guys?

Menof your info everytime is very well appreciated. Thanks a lot..

[Jeg]

And something else. My Yoke core with 24V input, 6+6 turns primary and 28Turns secondary gives less than 200V pk-pk with nothing else connected at it. When i connect it to the bifi is not more than 50V pk-pk.
How ruslan with the same turns and 12V input reach 220V?

[Jeg]

Here Ruslan schematic.

Menof..
At yours schematic, bifi coil is different than ruslan shows. Ruslan's drawing show a bifi wounded as exactly the blue aquarium coil, and at your schematic every layer cancels the other. The overall inductance is very different to those two coils. Your way of winding will give not more than 30uH, and blue coil is over 100uH. Why is that difference in those two schematics?