Kapanadze Cousin - DALLY FREE ENERGY

[d3x0r]

@itsu
maybe you have some low ohm resistor you can use for current sensing?  (CSR)  and install them around the yoke? 


Since induction doesn't really matter if there's constant to it (at this point) it's the changing current that matters... so really anything on the pulse dirver longer than the rise of the current is wasted

[itsu]

hi itsu,

I saw the ringing in your waveform and i spotted someone at 4HV.ORG had somewhat the similar the similar problems to yours.

Base on similar ringing waveform the solution a another person applied for his tesla coil project was to up the capacitor to 4700uf across the power supply rail near to the yoke.

Please see attachment-

Please don't trust fully trust the snubber portion in Akula circuit.If the above solution i provided don't work at all.
Are you using fast diode for snubber section?
Do try to search for alternative solution related to tesla coil ot flyback driver or snubber circuit design idea.

Thanks Magpwr,

i used the original Ruslan diagram where it has for the 12V filtering to yoke: 100uF, 460nF, 100uH, 460nF, 100uF.
This 12V is measured to be rock solid, but i can try the additional 4700uF on the new setup as i have dismantled the MOSFET circuit now.

For using fast diodes etc. see my previous posts where i mention exactly what components i was using.

Regards istu

[itsu]

@itsu
maybe you have some low ohm resistor you can use for current sensing?  (CSR)  and install them around the yoke? 


Since induction doesn't really matter if there's constant to it (at this point) it's the changing current that matters... so really anything on the pulse dirver longer than the rise of the current is wasted

d3x0r,

i have some ac/dc current scope probes, so i can use those if needed.

Yes you are right about: "anything on the pulse dirver longer than the rise of the current is wasted",  i learned that way back in this thread here:
http://www.overunity.com/12736/kapanadze-cousin-dally-free-energy/msg337619/#msg337619

Regards Itsu

[Acca]

 Here are some new clips on the Rusaln device by Russian duplicators !!

http://www.youtube.com/watch?v=ShlCwA0g1Ro

http://www.youtube.com/watch?v=XtEYQrr056g

http://www.youtube.com/watch?v=pQZkTRgwFWY

http://www.youtube.com/watch?v=EIyls_pvMA0

https://vk.com/doc8712300_325715744


Acca .....and a happy song from Slovinia that make me happy to sing !!!

https://www.youtube.com/watch?v=KNAKe3rkO9w

Thanks to Rusaln !!! music is the key to a better mental state, even in the horrible wars of  [/font]oil  and gas  ... i..e Ukrainska wojna z Rosianami!!!

[Jeg]

@all
Hi guys. Do you know if i can use IR2110 for P-Mosfet driving? I have quickly read its specs but can't see something relevant.