Kapanadze Cousin - DALLY FREE ENERGY

[Jeg]

Itsu,


The waveform shown previously is badly attenuated and distorted from the original pulse shown below taken at the gate of the mosfet (output of TC4427) and is basically at noise level. As you have found, the 'P' channel / 'N' channel mosfet combo does appear to degrade the pulse. I am not yet hooked up to the Karcher coil.

Hoppy i get the same dirty waveform at the base of my katcher TR. But at the HV end of Katcher coil, is a clear sinus. Still playing and testing different connections between yoke's sec. and the other stuff.
Is anyone else that find a resonance at around 650KHz at his grenade coil? (5cm diameter, 48-48,24-24,12-12) 

[Hoppy]

Hoppy i get the same dirty waveform at the base of my katcher TR. But at the HV end of Katcher coil, is a clear sinus. Still playing and testing different connections between yoke's sec. and the other stuff.
Is anyone else that find a resonance at around 650KHz at his grenade coil? (5cm diameter, 48-48,24-24,12-12)

Jeg,


As I understand things, the nano-pulse should be switching the power to the Kacher. I suspect that your dirty pulse is not doing this and that you are getting enough base bias from the 12V rail via R13 to start the Karcher oscillating.

[magpwr]

hi everyone,

There is no activity commenced yet at my end related to this project.

Just managed to buy 2 different types of "USSR yoke cores" in ebay only yesterday while searching for 3000MN ferrite ring to construct a "pulse transformer".

I have attached my compilation of various IGBT drivers to show it's delays in ns."Waiting for some of those faster ones eg:TC4451,TC4452,IXDxxx which i can my hands on"
Also purchased the KT926 in ebay to test with 2SC5200."Usual Waiting"

Also got me Russian pulse capacitor -PIO capacitor 400volts 20uf which was sold as pairs from a seller in "Bulgaria"

In one of the Ruslan video some of you may have spotted Green earth cable is going to green terminal block in the electrical box.
"Nothing much to report in this case. But merely to let you guys know what is it to prevent any doubts"
http://products.ensto.com/catalog/15176/product/23309/KE61.3_ENG1.html

My next experiment after nanosecond circuit will be the Russian Yoke core to observe max voltage and etc while running at 27khz duty cycle unknown at this moment.

AFC-Automatic frequency control is implemented into my existing PWM generator  SG3525AN using variable pot to get around 10ohms which will be combine with my small toroid around 30..35turns.But not fully tested until yoke arrive in 1 month+.

"Holiday season is approaching therefore delivery of items is gonna take little longer"

[Jeg]

Jeg,


As I understand things, the nano-pulse should be switching the power to the Kacher. I suspect that your dirty pulse is not doing this and that you are getting enough base bias from the 12V rail via R13 to start the Karcher oscillating.

Perhaps u r right cause I have a fixed bias resistance. I will change it to a pot. Thanks

Nice yoke Mag! Good luck on experimenting!

[Hoppy]

hi everyone,


Just managed to buy 2 different types of "USSR yoke cores" in ebay only yesterday while searching for 3000MN ferrite ring to construct a "pulse transformer".

Ahh, that looks like the magic black stuff.