Kapanadze Cousin - DALLY FREE ENERGY

[itsu]

Attached is a scope shot of the current waveform (moustache) taken from my current transformer and voltage waveform across inductor cap. The frequency reading shown is not stable and is actually 33.3KHz.

Hi Hoppy,

that looks very similar as the Ruslan scopeshots.
What are you using for current sensor and where in the circuit is it?

Thanks,  regards Itsu

[itsu]

Hi itsu,

The LC resonant points will shift with any influence added. However, the main thing here is to treat grenade coil as waveguide and the wire length determines the frequency  with regardless to any LC resonant frequencies... Also the standing wave inside of coil should form on point where opposite winding is introduced and the grounding adds virtual wire for calculation. The SWR readings should help as well just we are looking for opposite from conventional readings when trying to get wave reflections in correct grenade coil spots for standing wave.

Cheers!

Thanks T-1000,

i see where you are going, but thats an area which has its own special technics 

Regards Itsu

[itsu]

Itsu or any body other (who have two chanel oscilioscope), can now you try make like in that schematic http://realstrannik.ru/media/kunena/attachments/3866/ruslanschemapodkliuchenia.png and then turn on kacher and turn off, to see or sine on multilayer coil is moving to one or other side, then kacher is turned on?
Ground can be were is not punctir and were is punctir line.

MenofFather,  i can try that, but as mentioned before, my current probe, or current transformer used does not show this
spiky current signal, perhaps Hoppy can show me how.

Regards itsu

[Hoppy]

Hi Hoppy,

that looks very similar as the Ruslan scopeshots.
What are you using for current sensor and where in the circuit is it?

Thanks,  regards Itsu

Itsu,

I'm using a high permeability toroid (20mm x 10mm) colour coded orange with a 12 turn secondary winding of thick ECW. The primary is one wire of the inductor coil just passing through the toroid as in meno's and Ruslan's videos. The toroid was a common-mode choke taken from an induction cooker mains filter unit. I stripped off one half of the winding.

Regards
Hoppy

[MenofFather]

MenofFather,  i can try that, but as mentioned before, my current probe, or current transformer used does not show this
spiky current signal, perhaps Hoppy can show me how.

Regards itsu

You not need use curent probe. You need mount on inductor wire, going to 3 turns on yoke, ferite ring like in my video (https://www.youtube.com/watch?v=lqcigiQcyPQ) with wounded 6-12 turns and to that turns conect oscilioscope.
And if you can please scan multilayer coil with conected to it 100 omh resistor (or if not have, then any, that you have 10-5000 omh) and without that resistor.