Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

Hi hoppy,

You may want to try either adding more bulbs say 300watts and try verify amp draw.Another approach try reducing duty cycle a little to sèe if bulb can be lit and check amp draw again....

Yes, I've done all that and bulb brightness always relates to amp draw.

[Jeg]

Yes, I've done all that and bulb brightness always relates to amp draw.

Hi Hoppy
Is there any case of not properly tuned coils?
Have you verified that both grenade and inductor lines have the same HF peak?

[itsu]

hi itsu and everyone,

Previously only myself and Hoppy have achieve this "pulsing effect" on the bulb.Both of us applied 60th sub-harmonics for the circuit...................

Hi Magpwr,

i don't know why you keep refering to the below screenshot when talking about 60th sub-harmonic.
Surely you can see that with 1 period of the big sine wave we have 3 periods of the smaller tesla (Kacher), meaning
there is a 1 to 3 frequency relationship, not 60

Or do i see/understand that wrong?

Regards Itsu

[Hoppy]

Hi Hoppy
Is there any case of not properly tuned coils?
Have you verified that both grenade and inductor lines have the same HF peak?

Yes.

[d3x0r]

So having the cap in series with the load, I'm able to use the magnet wire wound ferite that was pretty accurate in 1/2's and has a good stacking at the end... and get the appropriate output.


The one other longer ferrite does not work as well (better with cap)


So I swapped back to my 12g kapagen, and used signal generator on a few turns of wire and am able to tune to 745kHz and with cap in series get appropriate output... with a square wave also able to tune to 143kHz and get a low resonant point...


but if I drive using the cuffed coil... I have to go up to 1200Khz to get the high level resonant point... if I use just 8-10 turns it goes down to 840something... so the higher the inductance of the driver, the higher the drive frequency has to be....