Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

  Lots of comments... good.
  I finally got my Kacher's secondary coil sending the pulses to the antenna coil.
I was up to 1.30 am last night, playing with it all. As it's very sensitive to any interferences from the table, wires, the grenade coils, those inverted polarity turns,  etz... Just one wrongly connected inverted turn, and it wont work.
Really important too follow as closely as possible what Ruslan has done on the Akula second video clips.
 
  Still no increase in my bulb brightness though, not even one iota.
  I think that until in put on the proper fets in place of the smaller ones, I won't get to the next higher resonant peek, that may trigger the superposition to generate extra energy. 
  I think that we have to start from scratch to really understand all the complexities involved. And tuning may still take forever, to get it right.

[John.K1]

You can't compare collector impulses from a kacher with hv cap discharges into primary,...

One is asking- why Kacher in this design? Why not  discharges?

[Acca]

 Ruslan Kulabuhov cameo in this music video by Алан Шум и Алина Фэлдман - Бей по пузу (big papuza) ..  funny ...


https://www.youtube.com/watch?v=lPdWkgGgwR0

Acca ..

P.S... Ruslan is on Christmass vacation...[/font]

[Enjoykin]

Itsu you will get nothing from 1kV nanopulse generator in Akula device. He has used more than 35kV nano impulses in his device. Yes Dally has used nanoimpulses put his output have not been more than 60W. Output of nicely tunned 24V Katcher is somewhere around 30kV.

Best variant is trying build relatively small (in dimensions) Tesla Transformer like Akula did and use him instead Katcher. Akula design need very high potentials because Aether have threshold and make him response - you need shoot at aetheric barrier with very high potential.

So my conclusion is: Nano pulse generator is not good idea here,

Reg.

ps:  You can vary frequency of Katcher impulses in some range putting HV capacitors in series with output coil (base on transistor). If you want to see real power of Katcher give him 50V-70V 5A-6A input. Katcher is non linear Scalar transmitter - varying input power (both current an voltage) you move Scalar wave nodes and anti-nodes at your output coil. On several pages before was video link where maximum Katcher potential on hot-end was obtained lighting up 60W bulb in full brightness with 30Watt input. Try sweep input power directly from ЛАТР (autotransformer) and 4 diode bridge. If you using line filter for impulse suppresion connect it in bucking configuration.( start of windings counter each other - no shorting one winding).

[T-1000]

Hi all,

There was conversation with one of my friends and he told one thing - the katcher he used in Kazachstan required only few watts to make streamer on top of Tesla coil with smell of ozone all over place quickly and the same katcher requires 60W+ to make same in Germany and almost no ozone smell for quite long time.
Just wonder if that is the case with Earth telluric currents and Becker-Hagens Grid - http://www.crystalinks.com/grids.html

It might be looking like wild idea but I would like to hear some feedback from different places of Earth about minimal power requirements of your Tesla coil to make streamers and smell of ozone in entire room... That might shed some light about replication of Kapanadze/akula/Ruslan device.

Cheers!