Kapanadze Cousin - DALLY FREE ENERGY

[d3x0r]

Great build Nelson!
I like it for compact assembly

May you share circuit, coils winding and tuning so others who are building may try to make it as well? That would benefit everyone and especially ones who are living on poor countries and where electricity from the grid is costing fortune.
Also for us it would benefit with improvements you made from original circuit of Kapanadze/SR193/Dally/akula/Ruslan.

For naysayers - the unavoidable truth always wins in the end of the day...

He did say already he's not open source.

[AlienGrey]

Hi Nelson, you use a rather nice PCB on some of your devices for asembly, can you tell me were i can get some from and part number and what they are called  if that's ok. Many thanks Alien

[NickZ]

  So, concerning the Kacher...  I just did quick test on my Kacher circuit, which is now running on 24v.  And I was able to light an incandescent microwave bulb, 220v, 20w, to about 3/4 brightness. The bulb is connected to the 168 turns grenade coil, but the grenade is not connected to anything else. So, just by one end of the grenade coil going to the small bulb, and the other side of the bulb is going to the 37.5 meter earth ground. The other end of the grenade coil is OPEN.
So, now the small bulb will light up fairly well, the bulb will not light if both sides are connected to the grenade coil.
The grenades' output coil is showing a reading of over 1000v+, when not loaded by bulbs, just from the Kacher's radiated output.

[nelsonrochaa]

Hi Nelson, you use a rather nice PCB on some of your devices for asembly, can you tell me were i can get some from and part number and what they are called  if that's ok. Many thanks Alien

Hi , i bought in Farnel .

[starcruiser]

  So, concerning the Kacher...  I just did quick test on my Kacher circuit, which is now running on 24v.  And I was able to light an incandescent microwave bulb, 220v, 20w, to about 3/4 brightness. The bulb is connected to the 168 turns grenade coil, but the grenade is not connected to anything else. So, just by one end of the grenade coil going to the small bulb, and the other side of the bulb is going to the 37.5 meter earth ground. The other end of the grenade coil is OPEN.
So, now the small bulb will light up fairly well, the bulb will not light if both sides are connected to the grenade coil.
The grenades' output coil is showing a reading of over 1000v+, when not loaded by bulbs, just from the Kacher's radiated output.

@NickZ, rectify it and charge capacitors, then run an inverter. This should allow you to loop and self run.