Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

Hoppy,   good spotted, but also the second C** is missing (at the output caps) and we see a VD1 diode too which is not in the Allegga diagram,  hmmm.....


Thanks,  regards Itsu

Yes, indeed, I had not noticed the missing second C**. Diode VD1 on Ruslan's schematic (missing on Allegga's) has been raised by Tomtech and I'm hoping that he can post his interpretation of what he considers to be the 'correct' schematic. Then it will be a case of take your pick! 

Regards
Hoppy

[Jeg]

A self runner!

https://www.youtube.com/watch?v=lf-EmnlTHKU

Hi AlienGrey
Nice video, thanks for sharing. Do you have any idea what is this small thing like a capacitor that at 09:02 this guy dismantle from inside his transformer? He called it like..."genister" but i am not sure.

[Jeg]

Yes, indeed, I had not noticed the missing second C**. Diode VD1 on Ruslan's schematic (missing on Allegga's) has been raised by Tomtech and I'm hoping that he can post his interpretation of what he considers to be the 'correct' schematic. Then it will be a case of take your pick! 

Regards
Hoppy

Hi Hoppy.
It seems that this C** at the output is for better tuning the grenade with the right HF frequency. Normally it is in the order of some hundreds PF or some few nano.

[NickZ]

  All:
  Has anyone connected the two induction LC circuit together as is being shown in that diagram. Yes? No?

  Ruslan showed an electrolytic capacitor, a short fat one which if I remember correctly it was something like a 100wv, 2200uf of so.
I just can't remember the exact value, nor was able to fully see the value, but it was the one that he held it in his hand. That's the cap of unknown value shown on the schematic that goes next to the bulbs.  100v?
  The D1 capacitor was shown on several other schematics, sometimes it's two diodes, pointing one way in one diagram, and pointing the other way in another diagram, or a full bridge. I tried it using two diodes pointing towards the yoke, on mine.
This (below) is the diagram and circuit that I am following, in my own way.
  Check: Minute 8:41:   https://www.youtube.com/watch?v=C4egdVsOxmc

  Itsu:  When I mentioned that now my yoke is getting warm, it's just an observation. Unlike before I placed the missing 0.68uf capacitor onto the Mazilli crt. With this cap in place, the yoke heats up, where before it didn't but the fets would overheat, big time. Anyways, it's not important, just another observation. Not really trying to compare notes here. 
 
  I have my suspicions that the whole 3 turns coil/24,24t coil circuit is not really needed, at all. Probably the next thing that we'll see changed.

   

[itsu]

I would suggest you invert the trigger signal to the Kacher circuit, trigger it on the negative peak of the voltage sine-wave and delay it a bit using the RC circuit to line it up with the positive peak of the Current sine-wave.

Hmmm,  just found out that the signal on that switch (see diagram below) has the same polarity, only the amplitude differs, so flipping this switch will not have any effect.
Guess i need to connect pin 7 of the IR2184 to the switch, not pin 4 (or pin 8 of the 74HC14).


Itsu