Kapanadze Cousin - DALLY FREE ENERGY

[T-1000]

This discovery of mine revealed "Akula circuit" on kacher unexpectedly produced similar waveform as what was already shown by Sergey.

Forget that Ruslan cup cake.His stupid sine wave- kacher merely produce less than 6kv at 24volts.We need around 32kv.Worst no current to Earth detected.

The replication of waveform is nice but you still need pumping effect to the ground. The current transformer on earth wire with scope attached should help there.

[NickZ]

  What was the "pumping effect to ground", on the first Akula device when no ground is connected, and is still lighting bulbs.
  We don't even know if the effect is to the ground, or from the ground. Which is it?

[T-1000]

  What was the "pumping effect to ground", on the first Akula device when no ground is connected, and is still lighting bulbs.
  We don't even know if the effect is to the ground, or from the ground. Which is it?

The virtual ground also can be used. All what it is - the large capacitor plate. Can be big sheet of metal or just minus of the battery/capacitor.

[Hoppy]

  What was the "pumping effect to ground", on the first Akula device when no ground is connected, and is still lighting bulbs.
  We don't even know if the effect is to the ground, or from the ground. Which is it?

I speculate that its neither Nick. 

[NickZ]

  Something does happen to improve the output when the ground line is connected, but there may be more to it than the supposed pumping effect.  Possibly a polarization effect, instead. That's what I think may be happening at the kick-start moment. Once it is induced, the device continues on without it.  Similar to what happened on my device, lighting both a 50w, and 25w bulbs, from the kickstart of the induction circuit, which only needs a second to activate it, then the circuit runs on it's own from just the 30w Kacher circuit.
   So, there's lots more to work and experiment on.