Kapanadze Cousin - DALLY FREE ENERGY

[stivep]

Yes Grumage you are great  friend THANK YOU

quote :
what I do not  understand why we have double frequency'
yesssssssssssssss.............................

look at this video at its current time.
https://youtu.be/SPV89JWVdtY?t=85

the second one is from vibrating magnetic domains that are moving physically mechanically and switching magnetically..
we have 2 additional responses
these responses creates electrical response in any wire   winded on that ferrite including the first primary winding that was originally used for delivery of  driving signal



=======================================================================================================

   Wesley:
   I just edited my last post, so please check it again.
   NO, it's the Roma device that does need nor use ferrite in the cores, (not the Akula device).
And Poma's device (image below) can still produce 4000w output. And it can do so without the need of an Earth ground line to work just as strongly, as any other devices. So, it is NOT the energy coming in from the ground line, either.
   Yet, TK's ferrite-less device(s) are another good example, as you just pointed out.

this guy has something that he hides  on the left . As I remember  he was always using it. That was one of the reasons that I  did not pay to much attention to it.
Also he was always using big car battery in his first devices he presented to us.



Wesley

[Hoppy]

If you look back at the Kapanadze Aqua2 device with the strange looking copper wire loops at the end of the coil former, the tube appears to be filled with something. Several posts at the time this video was shown suggested that the filling might possibly be ferrite. Whenever ferrite is mentioned in conversation, I recall Bedini saying that Barium ferrite has special properties.

[stivep]

If you look back at the Kapanadze Aqua2 device with the strange looking copper wire loops at the end of the coil former, the tube appears to be filled with something. Several posts at the time this video was shown suggested that the filling might possibly be ferrite. Whenever ferrite is mentioned in conversation, I recall Bedini saying that Barium ferrite has special properties.

Yes i recall it. the red color coil filled in  something..

[stivep]

My dear Wesley.

With the assistance of Verpies I did several videos looking at ferrite using piezo stimulation. Starting here....

https://www.youtube.com/watch?v=SPV89JWVdtY

Four in between....

Finishing here....

https://www.youtube.com/watch?v=2TTM414t_zI

It was however, 3 years ago, much water has flowed down the river of life!   

With all best wishes, Graham.

I was also  playing with it  at that time too.

[NickZ]

  What Roma has on the left under the black hat or thing, is what's covering is the oscillator circuit, that previously was seen on the side of the Kacher coil, and it was also covered, but partly showing a very simple oscillator circuit for his Kacher/Tesla coil.
  The self runner, which was the last of 3 videos, only needed a car battery as the input source to kick start up the device, and afterwards was removed away.
  In any case, no ferrite can be observed anywhere. That does not mean that there is none in the Kacher tube, or the blue coil. But, it's not mentioned as part of the set up, or in the schematics or diagrams that have been posted. 
  That would be the best device to replicated, as it's so simple, cheap to build, and affordable for most people. IF it's the "real deal".
  Now he has removed all his videos, and only the videos that others have re-posted back onto YT can be seen.  Oh well...

   My point is the small laptop power supply (most likely about 19v, and 3 or 4 amps), used a his feed back loop, can't normally be supplying the 4000w output at the load. That can mean that the "extra" gain is being created, drawn in, or caused to do so by NMR, NAR, or other processes, etz... at the coils. Which ultimately adds much to what would be seen other wise, as the normal output power. And can also means that these types of devices can operate with and also without ferrite, or possibly even copper.
Especially if the process is not due to NMR of ferrite, copper, or any other gain materials. But, is due to the external surrounding "gain medium", instead.