Kapanadze Cousin - DALLY FREE ENERGY

[conico]

I believe this is the Ruslan's diagram with two transistors 2SC5200 and a mosfet IRFP 260, both on the radiator:

[apecore]

Well said lost_bro. I totally agree. I too do not have the time to just play around endlessly with the claimed self-runnier circuits so far shown, with no understanding on the principle of operation, in the hope that a Eureka event might happen by luck. I am happy to now just monitor the forums (with minimal comments about fakes  ), hoping I get some inspiration and motivation to experiment further from ideas being discussed. Its important that all avenues are explored through discussion.

Hoppy,  Lost_bro,
I completly agree....but combining the discussion with practical test would be effective?...or not?
It is all about objective teamwork and understandings

Greetings

[apecore]

I believe this is the Ruslan's diagram with two transistors 2SC5200 and a mosfet IRFP 260, both on the radiator:

So guys,
How abuut the tranistor,... does it  do as expected in this configuration?
Cutting the half period?

[Hoppy]

Hoppy,  Lost_bro,
I completly agree....but combining the discussion with practical test would be effective?...or not?
It is all about objective teamwork and understandings

Greetings

Apecore,

Yes, a combination would be effective and has been to a degree, when minds are steered by a common train of thought. Unfortunately but naturally, minds are diverted mid-stream down new avenues of research. There are many possible avenues for research into this device, making it difficult for forum participants to converge, concentrate and experiment and to share results arising from and based on a particular idea. Getting a firm handle on the principle of operation for these devices is crucial, in order to engender motivation to progress as a group in a common direction towards the design and build of a physical device.

[apecore]

Hoppy,

Again i agree...makes it all hard to get but even more fascinating.
Little steps.... confirmation.... and move on to the next step..
Must be possible with all those guys here.

Also....i have to re post my last post..
Posting and driving car is not a good combination.

Conico's schematic shows us a kacher interuptor not a 1/2 period eliminator.

Greetings

Modify 6:45..? Also i believe we have to slice the system to get inside functionallity clear and working in practise.
As i hope the discussion by lost_bro and others about the grenade and its PO... is clear but some if us bench_boys has to bring it in practise......of course by the supervisors engineers.
If we could provide such a co working environment.... it helps us all.