Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

   Verpies
    My 100X probe needed compensation,  so I adjusted it, and now it's OK,  no overrun.
    The duty cycle is going all the way down now also,  with no flickering as before.
   
   
   

[TinselKoala]

Shrink your photos please. There is no need for larger than 800 or 1024 pixels wide horizontally.

Beware of the focus pot. On many scopes it is part of the high-voltage circuitry. Yes, open the case and see if the plastic spacer is still connecting the front panel knob with the pot itself. Yes, if it is still connected to the knob but still cannot adjust focus, you can try replacing the pot, but be sure to use the same _type_ and resistance value and power handling value. Be careful! High Voltage Danger!

[AlienGrey]

Hi did any one have a play with making the PCB for the Nnalli device, but be aware of loads of circuit component placing errors and missing components, the problem appears to be all placed around the Tesla end of the device photo enclosed with rings round the offending component placings there is also a diode missing on the driver transistor and i would have thought the zener would be better placed  in the gate output stage..

PS any one got one working yet ?

[NickZ]

   TK.
   Good to see you posting here again. 
   Yes, I'll open up the scope and replace the focus pot.  It was working, but now it's not anymore.
.
   Thanks for the advice.

[verpies]

The duty cycle is going all the way down now also,

Notice, that your pulses look like up-pause-down-pause...
This is a different pulse strategy than up-down-pause...