Kapanadze Cousin - DALLY FREE ENERGY

[itsu]

Nick,

congrats on the scope, looks awesome.

Your fets (are they IRFP260N's?) should measure around 320K between drain and source, 138 Ohm is way to low, they look defective to me.
Do they still switch to 0 Ohm when touching the gate?

The gate signal screenshot (thanks) look to be with almost no dead time inbetween the pulses (hard to see on this scope), so try to reduce the duty cycle so you see a clear
dead time between the 2 traces, but first make sure your MOSFETs measure OK.

Itsu



EDIT, i understand that different DMM's could show different values on the MOSFET resistance, so that 320K value i see does not have to be the same on other DMM's.
Please take a look at this video for MOSFET testing, or use the linked procedure / drawing from verpies below it:

https://www.youtube.com/watch?v=gloikp9t2dA

http://overunity.com/12736/kapanadze-cousin-dally-free-energy/msg507003/#msg507003

[TinselKoala]

Gate signals are showing about one and one half divisions amplitude. At 20 v/div.... that's thirty volts on the gate signals. Too high. If the probes are set to 1x instead of 10x....at 2 volts per division that's three volts on the gate signals. Too low.

EDIT: Ok, I think I can see that the scope is actually set to 10v/div in the Gate signal actual scopeshot. SO ok, that's 15 V which should be OK.

[Belfior]

Hi everybody!

I have been interested in free energy since early 2017. After trolling in YouTube for 6 months I am glad I found this forum. It seems there are people here that are genuinely interested in Free Energy. My intuition tells me there is nothing in the Universe that says it is impossible. I doubt Tesla would brag about imaginary technology with his merits.

So I bought my first ever oscilloscope today and got 3 different TL494 ordered.

To me it seems these kapanadze-type circuits are all somewhat different. It would suggest that the underlying process is very forgiving and the circuits work EVEN with the technology in them. Should the efforts start with just blasting the coil connected to ground with some square waves to see if it is the ground waves that resonate back and give out the excess power?

I know I kinda jumped in here in the middle of years of experimenting and I may be out of line here, but shouldn't we start at the simplest possible arrangement? If there is such a method of amplifying power in Nature it is simple and beautiful. I think humans tend to separate themselves from Nature and build a wall of technology in between then and Nature.

If Tesla did all this with a spark gab and few coils should this be our starting point also?

When I get all the parts I will start going at this from a different angle. We can meet in the middle.

-Belf

[NickZ]

   Belfior:  Welcome.
   I can see that you were finally able to post. Good.

   I would start by building a kacher circuit first, and then to wind up the grenade coils. 
   After that, build the TL494 circuit, or buy one from Ebay ready made, for a few dollars.
   Cepren Stalker has one of the simplest TL494 circuit, shown on his last videos, that may be a good one to start with, and to replicate.

   There is no magic to be found in just the Kacher, or the TL494 circuits by themselves. The magic is found by heterodyning their combined interactions. And that is the main trick of these types of circuits.

   It's great that you can afford a new scope.
   Good luck.
                      NickZ
 

[TinselKoala]

"Cepren" -- approximating Cyrillic alphabet "Сергей" -- is pronounced "Sergey" or "Sergei"  in English spelling.