Kapanadze Cousin - DALLY FREE ENERGY

[Void]

I need to have my device working right, not overheating, and putting out a use able gain, first. I still can't run it for over a minute, due to these snubbers resistor or fets getting too hot. So, there is something that is NOT right with most all of the schematics, such as with Stalker's schematics. Which shows NO snubbers, at all.
I would have 350v peaks without any snubbers on, so those diagrams and circuits, just can't be the right way to go.

Hi Nick, I think Ruslan may have been using some of Allega's circuit designs, at least from
what I could gather from some people's comments at the time, and Allega showed
an RCD snubber to limit the big switching spikes in his schematic that was posted.

If other people are not using any snubbers then they may only be able run for shorter
periods of time without risking something burning out. It is possible to use just an RCD snubber
to limit the switching spikes and allow the ringing on the Drain waveforms as long as the
ringing is not going above Vds max, and you may be able to run the PWM driver under
heavy load for longer periods of time that way. Some people who have shown videos of
supposed self runners may only be able to run their devices for short periods of time
just to make a short video, and some people are using giant heat sinks with big fans
on them for their transistors, so they may be dealing with high heating on the transistors
that way.

[NickZ]

Nick,

It may be that with some feedback, your mosfets will stay cooler but without feedback you may never keep them cool at the high bulb power rating you are after. All the schematics show feedback, so I dont understand why you dont build the complete circuit and then experiment on a suck it and see basis as you are now. If Stalker can really self run his device with no snubbers, then at least connect up the feedback components before declaring that there is something wrong with the schematics.

  Hoppy:
  Stalker has not shown any his newer devices self running. Nor has anyone else, lately, for that matter.
If Stalker can get his rigs to self run by using the posted schematics, he doesn't show it doing so.  I would guess, that I know why...  So, I take in all these different videos and schematics shown as current tests, and not as a done deals.


   I've already tried the feed back loop previously, but that did not drop the heating of the fets. Nor of any other components.
In any case I will connect up the loop, when I can. I only have a single 12v battery to replace the 24v PS that I'm now using for the input source. And I know that a 12v battery is all that's needed to kick start the thing up, but, it's not really enough to tune with, to get to it self running.   Just be patient, I'll show that loop, soon enough. I'm in no hurry, remember.

  Verpies said:  If you don't get the circuit working right in the first place, it will come back to bite you, later.
Or something like that...  and he was right.

[Void]

Which Stalker video shows a self runner?

[Hoppy]

Which Stalker video shows a self runner?

Also, which Ruslan video shows a self-runner?

[Void]

Also, which Ruslan video shows a self-runner?

I could have said 'supposed self runner', but that is redundant at this point.
No doubt everyone understands that any given video demo could be faked
or otherwise be misleading.