Kapanadze Cousin - DALLY FREE ENERGY

AlienGrey · March 01, 2018, 11:35:15 AM

Getting back to this device (Akula / Ruslan) device in particular, I was following a radio video live recording play back

ant way I was kind of hoping the he was going to show his device instead of just talking about it

any way he didn't to cut a long story short he was saying with that type of device you need a transmitter to create a 180 deg phase shift I think T1000 was saying this a while back but no one took him up on it. Also wasn't Don smith saying the same thing a good while back in one of his vids ?

NickZ · March 01, 2018, 03:43:36 PM

Quote from: Hoppy on February 28, 2018, 05:21:20 PM
Is that the protection diode in the PSU? If so, the Peak inverse voltage (PIV) rating is likely not high enough to prevent HV spiking on your supply line possibly damaging your PSU. Those cheapo Chinese PSU's are commonly sold for LED lighting applications, so are not designed to power devices that generate high voltages.

Hoppy:
The additional protection diode is on the positive 24v terminal or rail. Not inside the power supply.
I'll try some blue ceramic HV caps like AG suggested. I suppose that they connect up between the positive and negative rails? I still have not been able to eliminate the unwanted pulsing when the feedback power supply is also connected up.

Hoppy · March 01, 2018, 05:35:34 PM

Quote from: NickZ on March 01, 2018, 03:43:36 PM

Hoppy:
The additional protection diode is on the positive 24v terminal or rail. Not inside the power supply.
I'll try some blue ceramic HV caps like AG suggested. I suppose that they connect up between the positive and negative rails? I still have not been able to eliminate the unwanted pulsing when the feedback power supply is also connected up.

Nick,

As discussed in previous posts, the best protection is with the use of transorb (TVS) diode with a voltage clamping rating above the power rail voltage.

http://www.littelfuse.com/~/media/electronics/product_catalogs/littelfuse_tvs_diode_catalog.pdf.pdf

AlienGrey · March 02, 2018, 02:03:33 AM

Quote from: NickZ on March 01, 2018, 03:43:36 PM

Hoppy:
The additional protection diode is on the positive 24v terminal or rail. Not inside the power supply.
I'll try some blue ceramic HV caps like AG suggested. I suppose that they connect up between the positive and negative rails? I still have not been able to eliminate the unwanted pulsing when the feedback power supply is also connected up.

Hoppy I have some Here 16 volt ones shall I poke Nick a couple down the modem to him as it takes six weeks before he gets any thing, but great for bills

PS weather is a bit bad here almost arctic conditions, where is the FE sorry alternative energy ?

Hoppy · March 02, 2018, 03:35:18 AM

Quote from: AlienGrey on March 02, 2018, 02:03:33 AM
Hoppy I have some Here 16 volt ones shall I poke Nick a couple down the modem to him as it takes six weeks before he gets any thing, but great for bills PS weather is a bit bad here almost arctic conditions, where is the FE sorry alternative energy ?

Hi Alien,

Yep bit taters here! Emma has poked the beast right up the arse!! A couple of those in series should fit the bill.