25mV Joule Thief powered by peltier merely using our body heat -Free energy 24/7

[omdano]

Well ..  so..  How did u measure the voltage in the video ?
People usually use Oscilloscope but you just simply used a multimeter
Where did u connect the multimeter ?
(the output circuit voltage)

[TinselKoala]

Well ..  so..  How did u measure the voltage in the video ?
People usually use Oscilloscope but you just simply used a multimeter
Where did u connect the multimeter ?
(the output circuit voltage)

Did I link to the wrong video? Sorry, the video I intended to link to was just showing how to use a spindle bobbin to wind the toroid easily.

What video did you actually watch? There was no multimeter shown measuring anything in the video I "thought" I linked to -- and which still appears to be the one in the link.

If you want to see some measurements on a scope, why didn't you say so? You asked about how to make it easier to wind 100 turns on a toroid, I thought.

Here are some scope measurements of  JTs.
http://www.youtube.com/watch?v=6zFOhTU-bt0
(For some reason I say "50 milli Ohms" when I meant to say "50 milliAMPs" a couple of times when talking about the Current trace on the scope. Sorry about the confusion...)
http://www.youtube.com/watch?v=nqJPi35cRrE
http://www.youtube.com/watch?v=uLEyv2jbWrU
http://www.youtube.com/watch?v=9MxIXESkS3I
http://www.youtube.com/watch?v=KWDfrzBIxoQ

[scratchrobot]

So... did anybody try to Oscilloscope the output of this circuit ? (with any voltage input - please mention)

http://www.youtube.com/watch?v=dR3wQf7xqNM

[omdano]

lol
@TinselKoala
i should have tagged magpwr

i was talking about his main video in the OP

[magpwr]

Well ..  so..  How did u measure the voltage in the video ?
People usually use Oscilloscope but you just simply used a multimeter
Where did u connect the multimeter ?
(the output circuit voltage)

hi omdano,

There is no need for Oscilloscope since we are working with DC.

You will need to the "fix" hot or side for the peltier(which effect which wire from peltier produce + or -) since you are going to connect to 100uf or 1000uf capacitor at the input of joule thief(+ -).

The peltier (+ -) output is connected to multimeter and joule thief output is connected to multimeter in video.This is just for demonstration purpose.

This joule thief circuit can be completed in few hours since 100 winding for toroid will take some time."Need alot of patience"

That's all the advise i can give."Good Luck"