Free Solid State/mechanical energy

[brnbrade]

hi all. 

this is my first post. sorry my bad English.

I will try to explain some consideration.
I do not want add or to place idea of Erfinder, but, the magnetism and electric energy are one e different only in the frequency.

How thus?

  If to catch one magneto or  bar of steel carbon and to pass a small chain in form of frequency and its polos to place bobbins connected in parallel, we obtain to extract to power forces.
  It is the same principle of the magneto turning around the bobbin, but what it makes energy is how much the turn determines 60hz in cycles for second.
  What he determines the generation of being able is the frequency and not it mechanic moviment.
  Then I could say that to be able electric it is a question of magnetic frequency.
  In the device of Erfinder, the magnetos are made use in perfect order of frequency between polos N and S  in second octava.

  Erfinder congratulations. 
  Its simple and obvious thought opens the doors for new and intriguing key to understand the universe and its functioning.

[Trump]

Hi all,  I changed my posting as it seemed that I was off track, I will just read and then read it again   Sorry Erfinder .



Regards


Trump

[barbosi]

Here it goes, I'm making the first step stating the obvious.

1.it's about stress (potential), the higher the stress (potential), the more energy released. The easy way to associate this is with a rock on top of the mountain. It just rests there. But if put in motion, all its static (potential) energy is transforming in kinetic energy. The higher the mountain (potential/stress), the higher the energy. Induction is most efficient in this case. As we deal with a step-up transformer, on secondary will have a greater voltage. Also looking at the drawing, at all time there will be two physically opposed coils with opposition of phase, hence the stress is doubled. I'm not a motor guy, but if not the opposed coils but rather adjacent coils is the mechanism (to have a shorter path), the same principle applies.

2.The HV coils are closed upon themselves. How? F coils are in series and also with G coils that are in series too. The loop/circuit is closed by the capacitor. All this closed loop circuit can be easy charged (and eventually may maintain its energy if needed). There is a pretty crude drawing attached showing this. There are no coils, nor correct spatial distribution, it shows just the closed path.

3. F and G coil fields are in phase with their corresponding primaries, so the contribution has an enhancing role towards the rotor.

4.Because secondaries cumulate a great inductance, the capacitor might decrease in value

I hit the ice first, lets roll.

PS: I forgot about coils D (rotor). Again I'm not a motor guy but I think being closed by themselves means they are in series and closing the loop. A ring with 6 coils in series.

[Charlie_V]

Err hmm well... hmmm...  Firstly, I would like to comment on the patent that zepharim found.  Firstly, Tesla is talking about efficient mainstream motor operation.  Tesla quotes:

"operates disadvantageous by giving rise to false current which often reduces, what is known as, commercial efficiency of the apparatus composing the system"

If the power you are feeding a typically modern-day motor (and modern-day motors haven't changed in 116 years) then the maximum power will be delivered when the inductance is canceled out.  This is easily achieved by adding capacitance to the system.  Though I will not go into the details of this, he is simply "tuning" a motor for max "real" power input.  Remember, in Tesla's day, they had no idea what tuning was (Tesla discovered tuning).  This is a very special (very creative) method for adding capacitance since Tesla has figured out how to do this with a coil.  Very awesome, thanks for finding it! 

Secondly, and I mean no disrespect from you or to you Erfinder (and if you can teach me otherwise I will listen), but I strongly disagree with your statements:

Static electricity (electrostatics) as it is called is the dominant force!  It is the only force! 

and

So friends please don't waste your time day dreaming over what you can do with magnetism!  Magnetism is a dead end.  We will discuss this also.  I say over and over again "what we call magnetism" as what magnetism truly is we cannot use!

I have said this many times and I will say it again, magnetism is just as important as electrostatics.  But neither is the dominant force, they are both dominant.  Magnetism causes electrostatics, electrostatics causes magnetism, they go hand in hand (the yin to your yang ha!)  Magnetic fields are the kinetic energy of the universe, electric fields (electrostatics) are the potential energy of the universe.  The magnetic field is very special though - I cannot stress this enough, you all have no idea.  A permanent magnet does not lose flux when inducing voltage in a coil.  Thats all I can say at this time. 

"Ere many generations pass, our machinery will be driven by a power obtainable at any point in the universe. Through space there is energy. Is this energy (static) or kinetic? If static our hopes are in vain; if kinetic - and this we know it is for certain - then it is a mere question of time when men will succeed in attaching their machinery to the very wheel work of nature."

I know what this means, and it made me rather happy when I read it.  This kinetic energy he speaks of is the magnetic field, not the electrostatic field.  In Tesla's day, permanent magnets were not powerful enough.  Neodymium has changed that!  When applied properly (and right now no machine available uses the magnetic field properly) a flux change of 10 Gauss will produce 50mV, just think what a flux change of 530 will accomplish?!?!  Hopefully I will have that answer soon. 

Anyway, I have thought very long about how to use an electrostatic field instead of a magnetic.  The problem I run into is the fact that electrostatics have to be stored.  They must be moved from one point of the circuit to the other - they do not share.  A magnetic field does share, and this is the key.  I pray that Erfinder has found a method to allow electrostatics to share.  The only way I can see a use in electrostatics is to convert them to magnetic.  A very large voltage that discharges fully can produce a tremendous current.  I have seen this first hand.

[Charlie_V]

What you've said makes great sense to me barbosi.  Sorry that last post was to cover some of what was said earlier today. 

From what I see, the coils are closed because if you follow the wires, the left side of the capacitor is connected to the G's.  Following them around, the last G coil at the 9 o'clock position is connected to the first F coil.  This goes back around till the last F coil, at the 12 o'clock position, is connected to the right hand side of the capacitor.  To me, this forms a large loop of wire connected to the capacitor.

From what I said earlier (with my ever so fancy graphs  ), he is using reactive power, (which means power that you put out is returned back) to drive this motor.  It's incredibly ingenious!  I think it would be better if he placed permanent magnets on the rotor.  From the patent, it looks like he is using eddy currents to make it rotate. 

(Just added)  Oh yea, when they say "the grid is too large to modernize" this basically means that the old parts are rotting, there are so many interconnected wires across the nation that they have a hard time locating the rotting parts, and when they do it costs so much to replace that they can't afford it.  So, the power grid is rotting out from under their feet, and with more people ever mounting in the world, this rotting grid cannot support the increasing load.  Its actually way worse than this too, but they don't talk about it much because they don't want to instill fear.  Its not good guys, Erfinder is 120% right!