Ultimate proof of Magnetic Vortex, free book and videos

[tinman]

I will go back and review what was said and re-watch your videos.  The problem I am having is it takes me like 1 hour to watch a 5 minute video due to a crappy internet connection.  I may have also watched your videos out of order due to the high posting volume and a crappy connection.  I will give you the benefit of the doubt for now. 

Gravock

Gravoc-lets start again ,and put aside the misunderstandings. But yes,please feel free to go back and view in order(if you can with the slow internet conection),and you will see why i got uptight.
Anyway,in my test i was using a simple standard electromagnet,as pictured below. I show how there was no vortex of bubbles on the pole end of the electromagnet,and yet there was using a PM-my comment was what i observed in that test-nothing more.

[d3x0r]

Anyway,in my test i was using a simple standard electromagnet,as pictured below. I show how there was no vortex of bubbles on the pole end of the electromagnet,and yet there was using a PM-my comment was what i observed in that test-nothing more.

I know what was wrong; you need 240V and 100A instead of just 5A no that looked plenty strong... would be curious if ceramic magnets were used, if it's a matter of strength.

[tinman]

This statement is absolutely wrong and wasn't based on any experiments you were currently doing.

Gravock

This statement is correct as far as my test showed,which were done prior to the water test. Look at the picture below of a simple homopolar motor. We can place the conducting wire(the wire that touches the magnet) from the positive of the battery in/on the north end/south end,or center of the magnet,and it will spin in the same direction.Nothing speacial,i know-just saying. Of course i know that if we flip the magnet over,it will spin in the opposite direction,as it will if we swap the voltage polarity over.And if we do both at the same time,the spin direction wont change-all this i know Gravoc. Hope that clears that up.

[d3x0r]

what if the current is only going through the axis, and not radially?  (works also if it's stuck on a hanging plate, and the electrical contacts are literally on the ends)

[Cap-Z-ro]

TA quote:

A:  I post this thread

B: An intelligent inventive critter like Tinman gets inspired from the info here/in the book .......to do something WHOLLY DIFFERENT

C: Holy Sh*t!!!!!!!   Instant results




You left out a step there TA...finally someone catches him in a mistake (me)...we'll label that step B1.

You left out the part where you had to fight your way thru 9 yards of bullsh!t from naysayers, nitpickers, and shills, some of which are chronicled in my old but still relevant thread dedicated their activities...

http://www.overunity.com/14167/thread-for-naysayers-nitpickers-and-shills/msg410658/#new

There are more than 2 paid  in operation on this thread...or at least more than 2 accounts.

Chaos and flux is their method of operation...good cop-bad cop.

Regards...