Magnet Motor Generator

[synchro1]

Here's proof:

[synchro1]

Magluvin's spinning his satellite rotor with the large disc by hand. What would happen if Mag's ran the prime mover with a tiny electric motor and precisely measured the input with and without the smaller disk? Would anyone bet the input would drop with the satellite rotor joined to the drive rotor?


Lidmotor and JonnyDavro uploaded several cool videos demonstrating this effect with satellite spinners.

[topothemtn]

TinselKoala.

Why would you care if a video was ad supported ?

It might have no effect on the validity of the subject.

[synchro1]

I wonder how Lenz delay phase shifter coils would work coupled to the "Eleman Generator"? A rotor of parallel magnet rings, with wave reflector Lenz propulsion output coils on each ring, would speed the rotor up and require an increased speed adjustment from the prime mover to not create drag. This would result in additional propulsion from the output coils and result in steadily ratcheted increased output.


I built a PVC platform for my ball bearing motor here in Costa Rica, but since I'm returning to North America next week, I plan to wait to order the magnets from home.
 

[mscoffman]

@TK,

I agree with you fully. Why shouldn't he offer to purchase a second watt meter identical to the first?
Then he could interchange them during the run. Why *never* any rational validation? Why not make us feel good?

---

On the magnetic coupling. Actually I think magnetic gear coupling in the way Elemen applied it is genius.

You will notice the vast differences in diameter of the magnetic coupling. This will guarantee that it will slip.
The fact that it slips will almost guarantee this it is a harmonic coupling. Essentially it is an automatic
transmission that impedance matches the motor source Rev's to the destination generator's. As I have said
in the past, impedance matching is the key to overunity.

I don't know whether this is overunity but I'll bet it's very close.

   
:S:MarkSCoffman