Ufo propu engine, closed loop

[ltseung888]

Weighing the jumping magnet.

The Output Energy (mgh) can be determined reasonably accurately.  There is no need for any assumption.  The only consideration is the recording of the maximum height.

The Input Energy (V*V/R*t) requires the average Voltage at the Pulse.  What to consider as the Pulse can be a point for discussion. The duration of the Pulse can also be discussed.  However, the values are large enough to eliminate small connection or equipment errors.  There may not be need to use very expensive DSOs.

We shall encourage the World to replicate the results.  May be a competition...

[ltseung888]

Screen shot of the waveform by TS Lau.

The replicators can send equipment details, results, video and this type of waveform to confirm overunity.

At least four more solenoids will be wound by Bill Fung and TS Lau in the coming days.

We shall have at least two full sets of equipment - one to stay and one to loan out for short periods or for off-site demonstrations.

[ltseung888]

A word of Thank you to all those who helped to make the magnet repulsion experiment a success.

The Ninth design of the lead-out energy flying saucer was posted on reply 1 of this thread on July 7, 2015.  That design could provide lead-out energy via the pulsing and unbalanced rotation of the coils and magnet.  It could also provide the net thrust.

I discussed that design with the Late Mr. Lee Cheung Kin.  His comment was: "You have graduated from kindergarten."  He was intimately associated with Tsinghua University and the Chinese Military.  He said that he knew which group produced the Nanjing UFO in 2006. 

I was deeply indebted to Professor Dennis Leung of Hong Kong University.  He advised me to do the simple proof-of-concept experiment.  He said: "Do one thing at a time.  Proving that mechanical energy output can be greater than electrical energy input is already earthshaking in the Scientific World."  He got his research assistant, Ms. Holly Kwok involved.  See reply 90 posted on September 3, 2015.

The initial results were not encouraging.  The one magnet and a 130 turn coil produced a jump height of 10 cm.  The COP estimated was 0.07. We speculated the reasons.  One possible explanation was not using ferrite rods that could increase the permeability hundreds or thousands times.  I consulted the advice of Mr. Tong Po Chi (builder of the Tong Wheel), Mr. Peter Chan (builder of the Chan Wheel), Mr. Chan of Wai Cheng (supplied parts of Tong Wheel) and many Church members.  My grand God Daughter, Miss Forever Yuen and family provided much moral support.  My old Wah Yan Classmates, Mr. T.S. Lau and Dr. David Chan gave encouragement.  Their encouragement provided the fuel to continue.

We focused on the need to use ferromagnetic material.  Mr. Bill Fung used his own funds to buy the electromagnets in November and Professor Leung et al did the experiment with very disappointing results.  The electromagnet jumped only 1 cm.

Meanwhile, Jesse Seligman got his friend Simon Roberts and Melanie Low to interview me for a video on lead-out energy flying saucer.  I got the equipment back from Hong Kong University.  I added one magnet for the jump and used a winding more than 200 turns, the result improved to more than 20 cm.  I then bought additional magnets and was able to do the successful experiment.  There are many others I might have forgotten to mention especially those whom I never met in person but communicated via the Internet.

Last but not least, I thank my son Daniel and Jennifer who tolerated the many years of jokes and jeers from those who remarked: "Your father is a Physicist but works on UFOs!"

[ltseung888]

The next steps:

The significance of the simple magnet and solenoid repulsion experiment demonstrating overunity will be earth shattering for the Scientific World.  Prof. Dennis Leung was right.  This single experiment replicated and confirmed by multiple reputable Universities will prove that overunity is possible.  Lead-out Energy Researcher will no longer be laughed at. 

To make sure that no experimental or equipment error occurred, we shall do the following:

1. Produce at least 4 more solenoids with different windings.
2. Have 4 more jumping magnets with different number of magnets.
3. Use at lease four different DSOs to ensure that there were no errors due to equipment.
4. Use at least two different DC Power supplies.
5. Use different wiring, clipping, switches.

Have at least two complete sets of equipment.  One shall stay in my home.  One can be loaned out for demonstration purposes.

Encourage Universities and other research organizations to independently set up their equipment and perform the experiment.  Encourage them to share the results.  Let Hong Kong University publish the academic paper after full confirmation.

I expect many Nations and Institutions will look at reply 1 in this thread and start to build the lead-out energy flying saucer.  The Race to benefit all humanity is ON.  I am sure that Nations such as Japan, Russia, Europe, India, Ethiopia and many "unexpected" Nations will be successful not only in replicating this experiment but will also get a lead-out energy flying saucer to function.

Is it possible for China or USA to deny that they are working on UFOs?  Is it possible for the debunkers to mislead the World in light of the undeniable scientific evidence?

The Divine Wine is for all to share...  Love Thy Enemies...

[John.K1]

And what about to think Rodin's coil?  https://www.youtube.com/watch?v=oqjOuk7K9U0