The new generator no effect counter B. EMF part 2 ( Selfrunning )

[ARMCORTEX]

Magnificent and simple.

Questions

1: What is material of rotating hub , iron tube ... ? Specific alloy needed?
2: What material is rotating magnet
3: What is space, clearance, between rotor ( not rotating) and stator. 2 mm ? 1 mm? Does it matter for precision ?

thx you for your gift.

[gyulasun]

Hi syairchairun,

You wrote two different email addresses in your two videos and none of them works, at least a member, Chet here reported delivery failure for both:

http://www.overunity.com/15071/the-new-generator-no-effect-counter-b-emf/msg422993/#msg422993

This is what you wrote in first video as your email :      syairalamsyarazab@yahoo.co.id 

And this is what you wrote under your second video: syairalamsyahrazab@yahoo.co.id 

So is there a valid email address for you?

Gyula

[syairchairun]

Magnificent and simple.

Questions

1: What is material of rotating hub , iron tube ... ? Specific alloy needed?
2: What material is rotating magnet
3: What is space, clearance, between rotor ( not rotating) and stator. 2 mm ? 1 mm? Does it matter for precision ?

thx you for your gift.

1. Soft iron plate 0.5mm, iron tube only holder to easy when i cutting, and must be open when assmbly wth holder alumnium, holder must isoltor mterial, and holder must be connected by shaft output, so shaft any 2 ( 1 shaft for rotor spin and 2 shaft for magnet or elctromagnet ), and any bearing to join them.
2. magnet not spin.
3. I use 0.5mm.

[syairchairun]

Hi syairchairun,

You wrote two different email addresses in your two videos and none of them works, at least a member, Chet here reported delivery failure for both:

http://www.overunity.com/15071/the-new-generator-no-effect-counter-b-emf/msg422993/#msg422993

This is what you wrote in first video as your email :      syairalamsyarazab@yahoo.co.id 

And this is what you wrote under your second video: syairalamsyahrazab@yahoo.co.id 

So is there a valid email address for you?

Gyula

Sory, my email ; syairalamsyahrazab@yahoo.co.id ..

[Dave45]

How do the inner magnets stay stationary and the shaft rotate