ZERO INPUT, 10 degrees thermal output...Yes,...genuine free energy

[profitis]

My bismuth/bismuth sulfide experiment from earlier on was prone to error I see today.as the current has gone into reverse mode thus cannot rule out noise heat gradients.sorry folks,apologies.perhaps a large piece bismuth like ken used will do better?

[TheoriaApophasis]

Well when a guy says that a lump of metal sitting next to a magnet is allegedly an unlimited source of heat energy I call that "free energy."

the simplex nature of magnetic divergence against the HIGHEST order of LOWEST MAGNETIC PERMEABILITY (= diamagnetic) .........eludes you.



All force (energy) is the loss of inertia.       There is no energy without the loss of inertia.


Force without loss of inertia ( free energy, overunity).......does not exist.

[profitis]

Quote frm ken:
All force (energy) is the loss of inertia.       There is no energy without the loss of inertia.


Force without loss of inertia ( free energy, overunity)....doesnot exist'

End quote

If your bismuth ball heatsup above ambient with no effort it is most certainly free energy and definitely a violation of the 2nd law.it is free work against kelvin statement

[TheoriaApophasis]

If that bismuth ball heats up without effort it will be in direct violation of kelvins famous statement thus it will definitely fall under wikipedias perpetual motion definition

without effort?  ........ You mean the dump/loss of inertia.........no such thing exists NOR is implied


perpetual:........  as long as the coherent polarized reciprocating magnetic divergence is present against the LOWEST magnetic permeability metal (the bismuth), then said force lines can and do cause very minor heating.


that however is not perpetual. maybe connotatively so, but not in reality or definitionally.




magnetic "lines of force" are indeed FORCE,  theyre the loss of inertia, expressed as FORCE and MOTION.


The greatest elemental RESISTANCE TO SAID FORCE, .......is bismuth   (this is in dispute by NOBODY on EARTH, at any time).


Dielectric field torsion expressed by low magnetic permeability by said bismuth in the presence of a strong magnetic divergent force density....... is translational into and AS heat.



Its not even complicated.

[profitis]

Quote frm ken'without effort?  ........ You mean the dump/loss of inertia.........no such thing exists NOR is implied'

I didn't say that.kelvins 2nd law statement strictly prohibits any spontaneous concentration of heat against ambient.thus your device is by definition absolutely,totaly free energy and true perpetual motion.unless the ball heats up temporarily