Partnered Output Coils - Free Energy

[EMJunkie]

Ummm...Brian...this is an OPEN SOURCE website.  That means...full disclosure of your device. (If you actually have one)  If one does not want to do that....perhaps they should choose a site that is not OPEN SOURCE.

It is not an Almost open source site, or a somewhat open source site...it is OPEN SOURCE which requires full disclosure.

I hope this clears things up a bit.

Bill

Brian, don't get tangled up with this jellyfish! He's the resident Follower and like to say things he cant understand.

Bill runs his whole house on a Joule Thief

Same battery that his dad gave him - COP = Infinity!

Or is it that his Dad was a COP? Hmmm

[EMJunkie]

EMJ,

The first thing I would do is to connect a decent HF cap (ceramic, etc) between your V+ and 0v as close to the components as possible.  Also, reduce all component interconnecting wire lengths.  Why does "overunity" always require clip leads?  Think "impedance", not "resistance". 

To those that have been here a while, this sounds all too familiar...

PW

Thanks P! I will

I don't think an answer will present itself fully so I keep going on what I have.

Thanks again, you've been one of the most helpful here!

[Pirate88179]

We know about your kind with your Brute Squads rounding up and eliminating innocent stray inductances and forcing your pig decoupling capacitors upon the unsuspecting.  No rat's nest is safe when your jack booted thugs come to town clearing them out in the name of "measurement purity".  Yours is the kind that destroyed Steven Jones 8X overunity JT circuit.  Now, just because EMJ wants to move his probes around, you'll likely get on his case for using a 6" ground clip to a node that isn't on the branch he says he is measuring instead of a coaxial connection to a node that is on the branch.  And what will you do when you have these machines where you want them?  You'll hook them up to the measurement machines and take all the overunity out of them, just like that.  How can anyone stand such cruelty to clip leads?

Pico did that?

How can that be?  Dr. Jones is a Physics Professor is he not?  I don't get this.  Everyone knows that to get overunity, you just have to have a bunch of clip leads lying all over your bench.  The more disarray they are in, the better the readings.  Oh, and you also need either a battery, or, a power supply.  All O.U. videos have this.  Of course, some low tech vids have only an AC cord but, we all know what is really needed to show O.U. in a vid.


O.U. is like the Heisenberg uncertainty principle.  Whatever instrumentation you use to measure it...especially really high quality instruments used properly, makes the O.U. go away.  It is only there until you try to measure it.

Bill

[Pirate88179]

Brian, don't get tangled up with this jellyfish! He's the resident Follower and like to say things he cant understand.

Bill runs his whole house on a Joule Thief

Same battery that his dad gave him - COP = Infinity!

Or is it that his Dad was a COP? Hmmm

My late father was an engineer at Bell labs in Murry Hill, N.J.  Perhaps you have heard of it?

Bill

[TinselKoala]

Sigh.

Here's my two cents worth.

First, the schematic I used and the photo of the build, and frequency used.

(The thing sings loud like Beverly Sills.)