Partnered Output Coils - Free Energy

[EMJunkie]

@ALL,

Why are we configuring Two Output Coils so that each Magnetic Field is Opposing each other?

Kind Regards

   Chris Sykes - hyiq.org
   To Reach New Horizons!

[SkyWatcher123]

Hi folks, Hi emjunkie, thanks again for sharing.
I finished making the coil former and winding coils, will be testing soon.

The bucking causes a ping pong action, that alternatingly induces more output in each coil and possibly increases frequency as well.
I have a feeling magnacoaster uses similar principle and many others no doubt.
peace love light

[EMJunkie]

Hey SkyWatcher123,

I finished making the coil former and winding coils, will be testing soon.

Excellent Work!

@ALL,

Why are we configuring Two Output Coils so that each Magnetic Field is Opposing each other?

Kind Regards

   Chris Sykes - hyiq.org
   To Reach New Horizons!

The bucking causes a ping pong action, that alternatingly induces more output in each coil and possibly increases frequency as well.
I have a feeling magnacoaster uses similar principle and many others no doubt.
peace love light

Spot On! Any Conductor that see's a Changing Magnetic Field in Time will experience a Magnetic Force, Lorentz's Force.

It increases Charge Separation!!!

Floyd Sweet said:
"If the directions of the two signals are such that opposite H-fields cancel and E-fields add, an apparently steady E-Field will be created. The energy density of the fields remain as calculated above, but the value of the E-field will double from E/2 to E."

Kind Regards

   Chris Sykes - hyiq.org
   To Reach New Horizons!

[gotoluc]

In the last device shown, the best I was able to achieve was COP = 1.7

Kind Regards

   Chris Sykes - hyiq.org
   To Reach New Horizons!

Hi Chris,

could you please do a new video of your latest device with COP = 1.7 ... but this time attache a 10 Ohm resistor (instead of bulb) and have your scope probe across it displaying RMS voltage.

This would be of great help to start the replications going.

Thanks for your time and sharing your results

Luc

[EMJunkie]

Hi Chris,

could you please do a new video of your latest device with COP = 1.7 ... but this time attache a 10 Ohm resistor (instead of bulb) and have your scope probe across it displaying RMS voltage.

This would be of great help to start the replications going.

Thanks for your time and sharing your results

Luc

Hi Luc,

You can see in this video: https://www.youtube.com/watch?v=ZhQgch4L5XY

Output Voltage goes up to 5.453 only after a few seconds of tunning. This is with a Resistive Load. Voltage and Current must be in phase through a Resistive Load.

A Resistor will not make any difference to this device, in fact if the resistor is wire wound it will not give an accurate result.

Without doing a rebuild on this device, as it is now parts in a box somewhere, re-building is a bit impractical.

I have however attached a Picture to show the RMS Voltage from the Video I have posted online at the above address.

I am not going down the "Measurement" path - Bill Alek a qualified EE has been ridiculed without any evidence to the contrary. My measurements are not up for debate here.

I am giving people the How's, Why's and the Secrets to build their own Devices. Its up to them to make their own decisions.

I encourage people to use their Common Sense and decide for themselves if this device makes sense and is worth the 1hr and $20:00 to Build and Learn.

Kind Regards

   Chris Sykes - hyiq.org
   To Reach New Horizons!