Partnered Output Coils - Free Energy

[hyiq]

Chris, I finish with you, no sense to continue.  Please remove  your point 4 line as I kindly asked you previously, I do not participate in your campaign here, ok?.  I wanted to help with my comments but you are making war.

Gyula

Gyula - I know, you mean well. I do not understand "Please remove  your point 4 line " What part do you mean? This is not clear and could mean anything to me?


I am happy to publically retract any statement if I have inaccuracy or a misunderstanding...


   Chris Sykes
       hyiq.org

[hyiq]

What a surprise
well Chris there is only one way a moderated member[Milehigh] gets his posts thru
and that is the Boss {Stefan}
the owner of OU.Com has to read and approve every single post.

which also means Stefan has to go thru the very annoying process of keeping track of this thread and its content
so no Chris its Not OU.Com "goons"

I see you have been talking lies about Stefan [the boss]  and others here ,so Now you will have the direct link you so desperately require to say these things to him Publicly .

also to note Gyula above is practically a saint here at this forum ,who also gives quite selflessly of his time
Gyula is unaware ATM that his request to have your torrid remarks removed [towards him] is only doable by Stefan
or a moderator .

Chet K - Clearly youre no Gentleman - You have also been asked many times to leave.


You refuse to, which shows your intent!


I will ask you again, Chet K Please leave and don't ever come back!


   Chris Sykes
       hyiq.org

Stillll Nottttt Leavingggggg...


   Chris Sykes
       hyiq.org

[partzman]

Within all the mud slinging there may be a ray of sunlight trying to shine thru!  Has anybody taken a close look at Itsu's video with the re-positioned current probe?  Only Itsu can answer this but if his sense resistors are accurate say within 5%, his measurements indicate OU with reasonable scope measurements.

I've attached a scope shot below of what I'm referring to.  Keep in mind that the current measurement is 10x so it is really 109.6ma rms and in phase with the input voltage of 1.431v rms. This equates to a Pin of 156.8mw rms.

The outputs are 136.6mw for CH1 and 42.77mw for Ch2 for a total Pout of 179.37mw for an overall COP = 1.145.  This efficiency is high enough to warrant more investigation IMO.

pm

[gyulasun]

Gyula - I know, you mean well. I do not understand "Please remove  your point 4 line " What part do you mean? This is not clear and could mean anything to me?
...
   Chris Sykes
       hyiq.org

As I wrote it is reply 7877.

Gyula

[hyiq]

As I wrote it is reply 7877.

Gyula

Hi Gyula - I meant no ill intent, merely was pointing out a communication issue on this comment and I am sorry you see this otherwise. I can not modify the post now as it is readonly, no modify button is available.

Please read PM, I have replied to you with more in there.

   Chris Sykes
       hyiq.org