Is Newton's Law At Risk?

[noonespecial]

I understand it completely. If you're right about the oscillation is the only reason why the CD-motor spins, you don't need a motor at all. You could just make a gear between the two purple flywheels and start spinning it by hand and released them. They would then power the CD-motor with its frictional loss forever.

Vidar

Apparently you don't understand. There already is a gear between the two purple flywheels.

[gravityblock]

We can replace the one way bearing with a scrollerwheel.  A scrollerwheel doesn't have the kinetic friction inherent in most mechanical bearings.  We can then convert the full reciprocating motion of the motionless axis by attaching a mechanical arm to it and the scollerwheel, or to one of the rollers inside the scrollerwheel.  This also eliminates the rope/chain and the friction associated with it.


References: 


Scrollerwheel, http://en.m.wikipedia.org/wiki/Scrollerwheel


Scroller Mechanics, http://erikbrinkman.com/Scroller/Home.html


Gravock

[gravityblock]

We can replace the one way bearing with a scrollerwheel.  A scrollerwheel doesn't have the kinetic friction inherent in most mechanical bearings.  We can then convert the full reciprocating motion of the motionless axis by attaching a mechanical arm to it and the scollerwheel, or to one of the rollers inside the scrollerwheel.  This also eliminates the rope/chain and the friction associated with it.
...
.....

Gravock

According to Linevich's publication on page 4, Newton's third doesn't apply in this case (because: action is always equal to counteraction along one general straight line and is not distributed to a perpendicular direction).

Gravock

[gravityblock]

While we're at it, let's replace the two unbalanced purple gears with two unbalanced scrollerwheels to eliminate nearly all of the kinetic friction of the device.


Gravock

[gravityblock]

By using the scroller wheels, eliminating the rope/chain and nearly all of the kinetic friction in the device, along with converting all of the reciprocating motion to rotary motion, we may achieve higher efficiencies than the electronically controlled customized clutch used by Karanev!


Gravock