Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



A commom Induction Motor as Free Energy Generator

Started by Tesla_2006, October 05, 2006, 10:15:27 AM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Tesla_2006

A common Induction motor can be transformed in a Free Energy Generator Making the following

1) Put diodes in the rotor for get a DC component in the induced currents

2) Put a filter in the supply lines of the stator for Get the low frequency induction component

3) Put a rectifier to the filtered signal in 2) for redirect that signal to the stator

In a induction motor the rotor turn at low frequency than stator, for example if stator currents is at 60 Hz , it can be 20 Hz in dependence of the mechanical load in the axis, diodes in the rotor get a DC component in the induced currents and the motor is transformed in generator, that DC currents get induced currents and a voltage induced between the supply lines of the stator at that low frequency, such as 20 Hz, that signal can be filtred by a LC filter and then rectified and returned to the stator, that DC current in the stator get induction currents in the rotor and go rising that DC component in the rotor, and so in many cycles that DC component and induction in the stator go rising to the power level desired until the device get autopowered, there is needed an automatic control switch for limit the power output
  There is monophase and triphase applications by using this not used magnetic energy in this common motor and is not neccesary think in build a new special motor with magnets and so use a common builded device


Bye, regards