Magnets, motion and measurement

[Floor]

Floor's  balancing neutralization part 2 video.

                   https://dai.ly/x7ffco0

                             floor

[Floor]

Restoring ceramic magnets, breif video.

https://www.dailymotion.com/video/x7ffe07

               floor

[Floor]

It is not problematic, If the output magnets have some attraction, when the shield
magnet array is in place.

https://overunity.com/16954/magnets-motion-and-measurement/dlattach/attach/173702/

  floor

[Floor]

@citfta

During the video demonstration  @ https://www.dailymotion.com/video/x728wd9

of the " MagForShld 1b.pdf"  @  https://overunity.com/18137/newtons-magnets/dlattach/attach/173835/

The Two magnets in the shielding position are glued together edge to edge.

They are in repulsion.

Note 1. One of  those ceramic shield magnets was considerably weaker than the other.  They did not shield well AT ALL, when
I reoriented/ flipped them top for bottom. 

I have since that time, done many repeats of those particular interactions, with well matched magnets in the shielding position, as well
as in the output magnet positions. I have had good results.  I have never mounted that configuration on track systems.

Note 2. notice (in the video x728wd9) that the shield magnet is not well centered (up and down).  This is why the shielding worked
only when oriented a certain way and not the other, one shield magnet extends beyond the tops of the fixed and output magnet.
I think that was the weaker of the two shield magnets ?

Note 3  given that your ceramic magnets are all from the same supplier / manufacturer, treating them with neo magnets can
equalize them nicely (video   @   https://www.dailymotion.com/video/x7ffe07  ).

         Thanks  for all your good work / experimentation.

                         floor

[Floor]

An innovation by I don't know who. Some combination of
communications and miscomunications ?

             floor