Magnet force shield

[norman6538]

Floor,

I did not appreciate your slam.

Encouragement would have been far better.

I did make a second one with smaller magnets and it performs better.
So I am encouraged.


Norman

[Floor]

@Norman6538

I apologize.

I appreciate your supporting this exploration / project, and mostly what I appreciate is
that you are a person of integrity on this forum.  Also I respect that you are willing to
see for your self and are neither a blind supporter, nor a auto pilot naysayer.

I meant what I said about having a test bed built, not as a slam, but as a real suggestion. 
...................................................
I don't think its a bad thing if some one is not a "craftsman", though perhaps you are one ?

I do not know this for a certainty either way... as to whether or not you have
or do not have the skill sets for replications.  It is not a put down.  You might be an
excellent school teacher or rancher or house painter or... you name it, you might also
be an excellent builder.

I do Know that in order to satisfy the reasonable critics, a degree of excellence is called for (rightly so).

I do Know that in order to satisfy the reasonable critics, a degree of excellence is called for (rightly so).
                           Again I apologize for the note of sourness in that post.


                     thanks for your diligence
                           best wishes
                                   floor

[Floor]

@Norman6538

Also, I appreciate your speaking up about it.


Please find the attached video link      http://www.dailymotion.com/video/x59r978

                            floor

[norman6538]

@Norman6538

Also, I appreciate your speaking up about it.


Please find the attached video link      http://www.dailymotion.com/video/x59r978

                            floor

Thanks Floor, I have seen too many well build devices that did not work that were a waste of time an money and I myself did some of them. Therefore I have learned to I start with a rough rapid prototype and then refine as I go. Today I am up to verson 3 and it is doing quite well. I hope to have measurement numbers within a day if not too swamped.

Thanks for your kind words - I read too much into your statement.

Have you done anything with the drawing that has the repelling magnets
and the stack between? Turning that magnetic repel force on and off easily really excites me.

I expect this to be my 3rd OU permanent magnet setup that I made and when you get to 3 devices that show more out than in its past time to wake up world.

VERY excited, - far better than the superbowl.

Norman

[norman6538]

My tests show work out to work in ratio of 1.82. So I now have made 3 OU devices that demonstrate that not all energy is conserved when permanent magnets are configured properly to demonstrate work done.

CONGRATULATIONS Floor.

Norman