Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of this Forum, I am asking that you help him
by making a donation on the Paypal Button above
Thanks to ALL for your help!!


Tom van Keulen coil v9 setup free open source

Started by indigo22, July 26, 2017, 07:19:54 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 ... 3 4 5 6 7 ... 28
User actions

indigo22

#20
July 28, 2017, 03:47:10 PM
i'm thinking of putting som kinda micrometalmix with epoxy into the aircore coil to maximize the performance

indigo22

#22
July 29, 2017, 07:37:13 PM
building the Tom van Keulen coil part 5 DIY Breakoutboard https://www.youtube.com/watch?v=VZgQp5TISPA&feature=youtu.be

indigo22

#23
July 29, 2017, 07:58:56 PM
ok how bout thiz we all built this thing and share i'll help you as much as i can but just build et

PARAV

#24
July 29, 2017, 08:58:27 PM

Quote from: indigo22 on July 29, 2017, 07:58:56 PM
ok how bout thiz we all built this thing and share i'll help you as much as i can but just build et
[/quote


Hi Tom.
I have the coil almost done.
I am having great difficulty in figuring out which jumper leads are going from the breakout board to the
trigger coil (is that the right one?)and which one goes from or to the PWM.
Can I use my frequency generator instead of a PWM ?
It is really hard to see and understand how the circuit is all hooked up on your videos as they are not very clear-with a lot of shadows and low light.
It would be a real  great help if you can make a  more detailed  schematic with all the connections
to and from the breakout board and the PWM and your coil wires as those things seem to the most important part of the project.
I am excited about this project but am frustrated in trying to figure out the connections,
I\m sorry to be a pain but I know you are really trying hard to get this out.
Thanx again--and appreciate all your help---Paul
P.S. I'm building the v 2 version



Print
Go Up Pages 1 ... 3 4 5 6 7 ... 28
User actions