Negative Inductance and measure of Magnetic force.

[ramset]

Allen
Quickly looked at the Vid during lunch [not the whole thing yet]
I see it is a fellow who does not allow comments ...[many here consider that an issue or big red flag] and the experiment is in an area which really requires enormous understanding of all the possible variables [measurements and such]

the good news

there is about to be a very extensive attempt to investigate a theory ,a theory based on solid scientific .....errr possibilities.. by several members here.
similar [vaguely] to the above video ....


and proper measurements will be at the very top of the To do list .

being sure that all input energy is accounted for and no erroneous assumptions are made such as environmental or background smog contributing to OUTput [unaware]

strict measurement protocols  are imperative in such experiments !!
and a daunting task to say the least.

is there no simpler "energy in ".. "energy out"  Video or claim you might offer for members to replicate here ?? to see or witness your claim?

a tesla coils is like a hurricane ...its reach and effects are hard to measure or qualify [with quality measurement protocols].
------------
On the upcoming experiments

many here are looking forward to this investigation ....

I am not certain where these upcoming experiments will happen as some builders here Chose to avoid the nonsensical attacks than can happen at this forum .....  plus attempts by other members who have never performed the experiments to posture themselves as specialists .

and then there are others who make all manner of assumptions based on terrible measurement protocols .

Not sure "yet" if your posted vid falls into the poor measurement  category ..
although I would imagine the upcoming tests will cover many assorted claims ..

no stone left unturned.

I SHOULD ADD

there will certainly be a spot where these experiments will be shared here.

as this is an open source forum and the work is open source [the only kind of work to bother with IMO].

respectfully
Chet K

[sm0ky2]

@chet


https://en.m.wikipedia.org/wiki/Negative_impedance_converter


When you have time for a read


This will help testing this sort of thing.

[synchro1]

@ramset,

Thank you for helping pay serious attention to my problem. I'm only a little guy.

I'm getting excellent results dropping the inductance from a .320 mH inductor choke down to close to nothing with a ceramic magnet sandwich. I'll be uploading a video shortly.

[synchro1]

O.K. I did it! Hooray! I'll wait for the morning to film and upload the video. I have a 10 loop thick uninsulated copper coil that measures .001 mH in the positive range with a small ferrite core, and in the negative range with the core removed with both the electrodes in place or reversed. This negative inductance reading indicates the presence of a minute magnetic field in the copper coil.


The .320 mH choke reduces to .050 mH with 4 ceramic magnets attached. I'll show both effects tomorrow.   

[synchro1]

@ramset,

Here's the video I promised. I hope this helps:

https://youtu.be/Yoqct2EdM4g

This video demonstrates the value of the "Inverse Henry".