Negative Inductance and measure of Magnetic force.

[synchro1]

The switch I'm using is the moduler 4 pin in the center that snaps out of the case: This will snug fit perfectly into the screw tube of the toilet fixture.

[/size]https://dl-mail.ymail.com/ws/download/mailboxes/@.id==VjN-1X9NaLC9ZX3FaL6CGMuswusjkt9d1-tx3R3qM3BRpHb3fu55JdZSfkPWvGRe0gruGl2LEeEb8L4Fd0GBJs5fOA/messages/@.id==AHLSrSEWj5a7XLs-vQAAAElvIzQ/content/parts/@.id==2.2/raw?appid=YMailNorrin&ymreqid=3365852a-c14e-b304-1c19-a80001019b00&token=zitEzqOML3j84e6ealFTT5U7-km5qEQF52lp7AcCuBYuSfoFz8vQYu01Ebe_f8pg2ITMlv4-3AvnkLQDemZLxHwtsH6_HC8hR_TqMSR7KK7Kq2x236OSj64rSSjwoc6v

[synchro1]

                                                      Microwave oven door switch
Quick and dirty "H" bridge:


Coil ends would connect to the common pins of each of two switches. The NO and NC pins should connect to their matching pins on the other switch by wires with stripped sections in the middle for the power: Negative to NC and positive to NO.

https://dl-mail.ymail.com/ws/download/mailboxes/@.id==VjN-1X9NaLC9ZX3FaL6CGMuswusjkt9d1-tx3R3qM3BRpHb3fu55JdZSfkPWvGRe0gruGl2LEeEb8L4Fd0GBJs5fOA/messages/@.id==AGL50y05czFAXLxn0wVi6DmhW1A/content/parts/@.id==2.2/raw?appid=YMailNorrin&ymreqid=3365852a-c14e-b304-1c47-c40001013f00&token=zitEzqOML3j84e6ealFTT5U7-km5qEQF52lp7AcCuBYuSfoFz8vQYu01Ebe_f8pg2ITMlv4-3AvnkLQDemZLxHwtsH6_HC8hR_TqMSR7KK7Kq2x236OSj64rSSjwoc6v

[synchro1]

                                                            Reverse direction

I noticed the monopole driver will move in the wrong direction from the same pulse if it's offset inside the coil core. The "Adams" kick needs to be looked at on an oscilloscope to see what's really going on and how best to synchronize these magnetic field shifts.


Running the "H" bridge monopole in Adams resonace and looping the flyback should deliver an OU COP. Timing the backspike to add power amounts to "Lenz Propulsion".

[synchro1]

The separated wave form below shows where we would position the monopole magnet on the ferrite oscillator driver to benefit from "Lenz Propulsion". The SPDT switch would be positioned to trigger exactly there. The magnet on the other end would be in the center of the coil awaiting the pulse; Centered so it would attract on one side and repel on the other.

[synchro1]

microwave door switch. wedged in pvc t with a chopstick.[/size]