Pierre's 170W in 1600W out Looped Very impressive Build continued & moderated

[d3x0r]

I can't find a lot of these now; but a couple weeks ago I saw several.

I figured it was included, because it's only a PCB that the current is going through, so the 4Ohm, 100W resistor is just a 3-4A current limiter... (12-16V); if there was no resistance it could easily be 120A or 240A if the ESR is 0.1-0.05

https://www.amazon.com/Farad-Electric-Double-Layer-Capacitor/dp/B00OYILTOA#feature-bullets-btf (2.7V 400F single cap)
ESR DC   <10mΩ

so 1200A. (well I guess; there's 6 in series so only 200A)


Although looking for the CSDWell capacitor balance board the specs say 'current: unlimited'  which I find hard to believe...


(image from here)
https://www.ebay.com/p/16v-60f-Ultracapacitor-Module-Battery-Eliminator-Car-Audio-Starting-Remot-Solar/1566177167?iid=262390228351&chn=ps

[r2fpl]

Power from diodes go to directly to cap. Only power supply from transformer is connected to resistor.

Why ? all the current goes from capacitors to relays ?

ONLY TWO THIN WIRES POWER RELAYS

it would mean that the current is created on the rotor, only ?!

[d3x0r]

Power from diodes go to directly to cap. Only power supply from transformer is connected to resistor.

Why ? all the current goes from capacitors to relays ?
only two thin wires power relays ?

it would mean that the current is created on the rotor, only ?!

That's the 5V power supply - V1; 0:46; (image clip from 0:41)

[r2fpl]

Pierre,

I know this secret. I will keep it for myself until others know it or tell it.
One of the films is "visible" this secret. You need to know what to look for and what is missing.
I confirmed it the way you did it and now I understand your surprise successfully!

I wonder about the time of work, and probably you too. Maybe you already know it but it's unusual.

Thank You !

[pmgr]

Pierre,

I know this secret. I will keep it for myself until others know it or tell it.
One of the films is "visible" this secret. You need to know what to look for and what is missing.
I confirmed it the way you did it and now I understand your surprise successfully!

I wonder about the time of action, and probably you too. Maybe you already know it but it's unusual.

Thank You !

r2fpl,


Your email is kind of a mystery. Did you figure out how to get your prototype to work? Can you confirm you successfully replicated Pierre's device?


Also, what do you mean by time of action?? Sorry, but your English is not very clear.


PmgR